Husqvarna 225R 232R 235R RD RJ Chainsaw Owners Manual

ASSEMBLY
Assembly of the blade and trimmer
head
Assembling the blade guard and
clearing blade
It is extremely important
that the disc drive’s/support
flange’s guide engages
correctly in the cutting
equipment’s centre hole
when assembling the cutting
equipment. Cutting
The guard (A) is fitted
using 4 screws (L) as set
out in the diagram.
NOTE! Use the
recommended blade
guard.
L
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.
Fit the drive disc (B) on
the output axle.
Turn the blade axle until
one of the holes in the
drive disc aligns with the
hole in the gear housing.
A
!
WARNING!
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter “Technical
data”. If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
G
Insert the locking pin (C)
in the hole so that the
axle is locked.
F
D
Place the blade (D) and
support flange (F) on the
output axle.
IMPORTANT INFORMATION
The machine must be equipped with the correct
handlebars, blade guard and harness if either a
clearing blade or grass blade are to be used.
B
Fit the nut (G). The
tightening torque of the
nut is 35-50 Nm (3.5 - 5
kpm). Use the socket
spanner in the tool kit.
Hold the handle of the
spanner as close to the
blade guard as possible.
The nut is tightened
when the spanner is
turned against the
Assembling the blade guard and
grass blade
C
The guard (A) is fitted
using 4 screws (L) and
the support plate (M) as
set out in the diagram.
NOTE! Use the
G
F
recommended blade
guard.
E
D
direction of rotation (left-
hand thread).
Fit the drive disc (B) on
the output axle.
Turn the blade axle until
one of the holes in the
drive disc aligns with the
hole in the gear housing.
Insert the locking pin (C)
in the hole so that the
axle is locked.
Place the blade (D),
support cup (E) and
support flange (F) on the
output axle.
When slacking off and
tightening the saw blade
nut, the hands may be
injured by the blade
teeth. Always hold your
hand protected by the
blade guard. This is
facilitated by the use of a
long box spanner. The
illustration shows the area
in which you should keep
the box spanner.
A
L
B
C
M
Fit the nut (G). The
tightening torque of the
nut is 35-50 Nm (3,5 - 5
kpm). Use the socket
spanner in the tool kit.
Hold the handle of the
spanner as close to the
blade guard as possible.
The nut is tightened
when the spanner is
turned against the direction of rotation (left-hand thread).
18
– English
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags, , , , ,
Model Year1995, 1996, 1997, 1998
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 30 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website