Husqvarna 225R 232R 235R RD RJ Chainsaw Owners Manual

MAINTENANCE
Air filter
Spark plug
The air filter should be
cleaned regularly removing
dust and dirt to avoid:
The condition of the spark
plug is affected by:
•  An incorrect carburettor
setting.
•  An incorrect fuel
mixture (too much or
faulty oil).
carburettor malfunction
starting problems
reduced engine power
unnecessary wear to
engine parts
0,5 mm
•  A dirty air filter.
abnormal fuel
consumption
These factors cause
deposits on the spark plug
electrode that may result in
malfunction or starting
difficulties.
If the machine is low on power, difficult to start or runs
poorly while idling always check the spark plug first.
Clean the filter after every
5 hours or more regularly
if operating conditions are
exceptionally dusty.
2
Cleaning the air filter
Dismantle the air filter
cover and remove the air
filter. Wash in clean, warm
soapy water. Ensure that the
If the spark plug is dirty, clean it and at the same time check
that the electrode gap is 0.5 mm. The spark plug should be
changed after about one month of operation or earlier if
necessary.
filter is dry before refitting. An air filter used for a long period
of time can never be cleaned completely. Therefore it is
necessary to replace the filter from time to time with a new
filter. A damaged air filter must always be replaced.
NOTE! Always use the recommended type of spark plug. An
incorrect spark plug can damage the cylinder/piston.
Filing the grass blade
!
Angle gear
WARNING!
Always stop the engine before you start
work on any part of the blade.The  blade
continues to rotate even after the throttle
has been released. Ensure that the blade
has stopped completely and remove the
cable from the spark plug before you start
to work with it.
The angle gear is filled
with a sufficient quantity
of grease at the factory.
However, before using the
machine you should check
that the angle gear is filled
to 3/4 with grease. Use
HUSQVARNA special
grease.
See the cutting
equipment’s packaging
for correct filing
instructions.
Normally, the grease does
not need to be changed
except when the angle gear
is repaired.
The blades are sharpened
using a single cut flat file.
Sharpen all edges equally
to maintain the balance
of the blade.
Two-part shaft
The end of the drive axle in
the lower shaft should be
lubricated with grease every
30
hours. There is a risk that
the drive axle ends (splined
coupling) on two-part shafts
jam if they are not lubricated
regularly.
!
WARNING!
Always discard a blade that is bent,
twisted, cracked, shattered or damaged in
any other way. Never attempt to straighten
a twisted blade for use again. Only use
original blades of the prescribed type.
26
– English
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags, , , , ,
Model Year1995, 1996, 1997, 1998
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 30 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website