•
Set the engine speed to the fastest position for the best
cutting results.
•
•
For light leaf coverage, set all the wheels at the same
cutting height setting.
If there are more than 5 inches (12.7 cm) of leaves on
the lawn, set the front cutting height one or 2 notches
higher than the rear cutting height. This makes it easier
to feed the leaves under the housing.
Warning
Operating a lawn mower with its engine running
at a speed greater than the factory setting can
cause the lawn mower to throw a part of the blade
or engine into the operator’s or bystander’s area
and result in serious personal injury or death.
•
•
Slow down your mowing speed if the lawn mower does
not cut the leaves finely enough.
If you mow over oak leaves, you can add lime to the
grass in the spring to reduce the acidity of the oak
leaves.
•
•
Do not change the engine speed setting.
If you suspect the engine speed is faster than
normal, contact an Authorized Service Dealer.
•
Clean the air filter frequently. Mulching stirs up more
clippings and dust which clogs the air filter and reduces
engine performance.
Cutting Grass
•
Grass grows at different rates at different times of the
year. In the summer heat, it is best to cut grass at the
2
inch (51 mm), 2-1/2 inch (64 mm), or 3 inch (76 mm)
cutting height settings. Cut only about a third of the
grass blade at a time. Do not cut below the 2-inch
(51
mm) setting unless the grass is sparse or it is late
fall when grass growth begins to slow down.
•
•
When cutting grass over 6 inches (15 cm) tall, first
mow at the highest cutting height setting and walk
slower; then mow again at a lower setting for the best
lawn appearance. If the grass is too long, the lawn
mower may plug and cause the engine to stall.
Alternate the mowing direction. This helps disperse the
clippings over the lawn for even fertilization.
If the finished lawn appearance is unsatisfactory, try one or
more of the following:
•
•
•
•
•
Sharpen the blade.
Walk at a slower pace while mowing.
Raise the cutting height on your lawn mower.
Cut the grass more frequently.
Overlap cutting swaths instead of cutting a full swath
with each pass.
•
Set the cutting height on the front wheels one notch
lower than the rear wheels. For example, set the front
wheels at 2 inches (51 mm) and the rear wheels at
2-1/2
inches (64 mm).
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need to
make more than one pass over the leaves.
13
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro 20039 |
| Model Year | 2004 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)