2.
3.
Insert the barrel on the cable end into the bracket
on left side of chute deflector (Figure 12).
CAUTION: Avoid injury! Explosive separation
of tire and rim parts is possible when they are
serviced incorrectly:
Hold seal out of the way while routing the cable
through the bracket on the left side of the
discharge chute, and then push the cable fitting
into the bracket.
•
Do not attempt to mount a tire without
the proper equipment and experience to
perform the job.
4.
5.
Push the seal securely over the end of the cable
fitting to prevent water from entering the cable.
•
•
Do not inflate the tires above the
recommended pressure.
Check deflector travel. Adjust nut on cable end
under handlebar to obtain full travel, if necessary.
(see Deflector Remote (921002, 003, 004) on
page 22).
Do not weld or heat a wheel and tire
assembly. Heat can cause an increase
in air pressure resulting in an explosion.
Welding can structurally weaken or
deform the wheel.
•
Do not stand in front or over the tire
assembly when inflating. Use a clip-on
chuck and extension hose long enough
to allow you to stand to one side.
3
2
1
3
Check Auger Gearcase Oil
Check oil level in auger gearcase (see Check Auger
Gearcase on page 19).
Check Engine Crankcase Oil
IMPORTANT: The engine is shipped with 5W-30 oil in
crankcase. Refer to Engine Manual for detailed
instructions.
5
4
Fill Engine Fuel Tank
Refer to Engine Manual for proper fuel type and tank
capacity.
1.
2.
3.
Cable Anchor
Cable End
Deflector Cable
Check Function of all Controls
Ensure unit runs and performs properly. Refer to
4
5.
.Cable Fitting
Cable Bracket
OPERATION on page 13.
Figure 12
OS7070
Run-in Attachment Belt
Check Function of Dual Handle Interlock
1. Start unit in a well-ventilated area according to
Starting and Shut Off on page 17.
Without the engine running, press down (engage) both
clutch levers. Release attachment clutch lever.
Attachment clutch should remain engaged until traction
clutch lever is released, then both clutches must
disengage. If they do not, contact your Dealer for
repairs.
2.
Engage attachment clutch lever and run
attachment for about 15 minutes.
3. Stop unit, wait for all moving parts to stop, and
remove spark plug wire.
4.
Adjust belt finger, if necessary. See Check Belt
Finger Clearance on page 26
Check Tire Pressure
5.
Adjust clutch idler according to Attachment
Clutch/Brake Adjustment on page 24.
Check tire pressure and adjust to the pressure listed on
tire sidewall.
GB - 10
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 921001, Ariens 921002, Ariens 921003, Ariens 921004, Ariens ST1027LE, Ariens ST1130DLE, Ariens ST824E, Ariens ST924DLE |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)