Ariens Sno Thro 921001 2 3 4 ST824E ST1027LE ST1130DLE ST924DLE Snow Blower Owners Manual

CLEAN ENGINE
Refer to Engine Manual for detailed instructions.
1
CHECK ENGINE OIL
The engine crankcase oil should be checked every 5
hours of operation. Oil level MUST be maintained in
safe operating range on dipstick at all times or engine
damage will result (See Engine Manual).
2
Park unit on a level surface. Refer to Engine Manual for
detailed instructions.
CHANGE ENGINE OIL
1.Auger Gearcase
Oil Fill and Drain Plug
2.
Change oil after first 2 hours of operation, thereafter
change oil every 25 hours (more often if required).
Refer to Engine Manual for detailed instructions.
Figure 22
OS7132
GENERAL LUBRICATION
Run engine just prior to changing oil. Warm oil will flow
more freely and carry away more contamination.
Remove the oil drain plug from the rear of the unit and
tip the unit back to help drain all the oil.
IMPORTANT: Wipe each fitting clean before and after
lubrication. Do not wipe gearcase filler plug; wiping the
gearcase filler plug may remove thread sealant and
cause leaks.
CHECK TIRE PRESSURE
IMPORTANT: DO NOT allow grease or oil to get on
Keep tires at pressure listed on the tire sidewall. See  
friction disc, friction plate or belts.
Check Tire Pressure on page 10.
NOTE: Apply Ariens Hi-Temp Grease or equivalent to
the lubrication fittings. See SERVICE PARTS on
page 29.
CHECK AUGER GEARCASE
IMPORTANT: Proper oil level must be maintained.
Sno-Thro should be lubricated (Figure 23) at beginning
of season or every 25 operating hours.
Gear cases are filled to the correct level at the factory.
Unless there is evidence of leakage, no additional
lubricant should be required. Check oil level each
season or every 25 hours of operation.
To ensure adequate lubricant level:
1.
Remove filler plug (Figure 22). Lubricant must be
at least up to bottom of lubricant filler hole with
unit resting on a level-surface.
2.
Add lubricant if required. Allow oil to drain to level
of plug and replace plug.
IMPORTANT: Use only Ariens special gear lubricant
L-2 (Part Number 00008000). Gearcase filler plug may
require an application of Loc-TiteĀ® 565 thread sealant
with repeated servicing.
GB - 19
Product Specification
CategoriesAriens Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 34 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandAriens, Snow Blower
Document File TypePDF
Publisherariens.com
Wikipedia's PageAriens
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website