2.
Tip housing and frame back together and secure
with hex bolts.
3.
4.
Place belt onto engine sheave.
Reposition and secure belt fingers.
IMPORTANT: With clutch lever engaged, belt finger on
the side opposite the belt idler should be less than
1/8
in. (3 mm) from belt, but not touching the belt.
Adjust belt finger as necessary.
7
2
2
3
5
1
1
3
7
4
6
4
6
5
1.
2.
3.
4.
Traction Drive Belt
Engine Sheave
Attachment Drive Belts
Belt Finger
5.Attachment Belt Idler
6.Attachment Idler
Adjustment Nut
7.Traction Belt Idler
1.
2.
3.Traction Belt Idler
4.Attachment Drive Belts
Spacer
Drive Plate Assembly
5.Traction Drive Belt
6.Engine Sheave
7.Friction Disc
Figure 44
OS7198
5.
Check adjustment. See Attachment Clutch/Brake
Adjustment on page 24
Figure 45
OS7144
3.
Pull idler away from traction drive belt and
remove belt from idler pulley, engine sheave and
driven pulley (it may be necessary to turn engine
pulley using recoil handle).
WARNING: AUGER / IMPELLER MUST
STOP within 5 seconds when attachment
clutch lever is released or unit damage or
serious injury may result.
4.
5.
Install new traction drive belt onto attachment
pulley and engine sheaves.
6.
7.
Reconnect chute crank and secure with spring
clip. Reconnect chute lock cable and deflector
cable.
Swing drive plate toward friction disc until finger
lines up with stop hole in frame. Slide drive plate
over, inserting finger into stop hole. Reinstall
drive plate spacer.
Replace belt cover.
TRACTION DRIVE BELT REPLACEMENT
NOTE: Make sure the drive plate assembly return
spring remains connected to the frame and nylon
bushing is in drive plate pivot hole.
NOTE: Replacement will be easier with housing and
frame tipped apart and bottom cover off.
1.
Remove attachment drive belts (see Attachment
Drive Belt Replacement on page 27).
6.
Replace attachment drive belt (See Attachment
Drive Belt Replacement on page 27).
2.
To gain belt clearance, remove swing gate spacer
and slide drive plate over so that finger clears
stop hole in frame and can swing past it. See
Figure 45.
FRICTION DISC REPLACEMENT
1.
Shut off engine, remove key, disconnect spark
plug wire and allow unit to cool completely.
2.
3.
4.
Place unit into service position on a level surface.
Remove both wheels.
Remove bottom cover by removing six hex bolts.
GB - 28
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 921001, Ariens 921002, Ariens 921003, Ariens 921004, Ariens ST1027LE, Ariens ST1130DLE, Ariens ST824E, Ariens ST924DLE |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)