5.
Loosen mounting nut on chute and move
chute up or down so that chute ring is
approximately centered between retainer
clip and lower ring and tighten.
1
3
6.
7.
Slide chute crank rod through bracket
under handlebar and through hole in
panel.
Align chute crank rod with the universal
joint on chute and fasten with spring clip.
2
12
1
11
2
7
3
4
5
6
1.
2.
Ring Gear Nuts
Half Rings
8
10
3. Discharge Chute
Figure 7
OS1930
Connect Battery (924300, 505, 506,
508)
9
1.
2.
3. Install battery cover and tighten wing
nuts.
Remove wing nuts from battery cover.
Install wire lead to battery terminal.
1.
2.
Pinion Bracket
Chute Strap
7. Gear Strap
8. Chute Ring
9. Lower Ring
10.Retainer Clip
11.Universal Joint
12.Spring Clip
3
4
. Pinion
. Flat Gear
5.
6.
Chute Bracket
Mounting Nut
Deflector Remote (924116, 505, 506)
1.
Slide cable end through hole on bracket
on left side of chute (Figure 8).
Figure 6
2. Attach cable eye to stud on deflector.
Hold in place with flat washer and e-ring.
DS0112
Install Discharge Chute - Electric
Rotation (924505,506)
Remove chute motor cover.
Remove the six (6) nuts from ring gear
(Figure 7).
3.
Check deflector travel. Adjust nut on
cable end under handlebar to obtain full
travel. (See Deflector Remote in Service
and Adjustments.)
1.
2.
3.
4.
Remove two (2) half rings.
Position Discharge Chute over threaded
studs with the chute opening facing the
electric motor.
5.
6.
Replace the half rings.
Replace the six (6) nuts and tighten to
120
in. lbs. torque.
7.
Replace chute motor cover.
GB - 13
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 1024, Ariens 1028, Ariens 1128, Ariens 1332, Ariens 1336, Ariens 924116, Ariens 924117, Ariens 924300, Ariens 924505, Ariens 924506, Ariens 924508 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)