Install new attachment drive belt:
TRACTION DRIVE BELT
REPLACEMENT
NOTE: Housing and frame must be tipped
apart and attachment drive belt removed from
engine sheave in order to change traction
drive belt.
1.
Place new attachment belt onto
attachment pulley.
2.
Tip housing and frame back together and
secure with cap screws.
3.
4.
Place belt onto engine sheave.
1.
Remove attachment drive belt (see
Attachment Drive Belt Replacement).
Make sure engine sheave and attachment
pulley align. If alignment is necessary,
loosen attachment pulley set screws,
reposition pulley and retighten set screws.
2. Pull idler away from traction drive belt and
remove belt from idler pulley, engine
sheave and driven pulley (it may be
necessary to turn engine pulley using
recoil handle).
NOTE: To gain clearance, engage traction
clutch and if necessary pull back attachment
idler arm clevis pin.
5.
Reposition and secure belt fingers.
IMPORTANT: Make sure belt fingers are 1/16"
to 1/8" (2-3mm) from belt when attachment
clutch is engaged.
6.
Check adjustment. See Attachment
Clutch/Brake.
3.
Install new traction drive belt onto
attachment pulley and engine sheaves.
Replace attachment drive belt (See
Replace Attachment Drive Belt).
WARNING: AUGER / IMPELLER
MUST STOP within 5 seconds when
attachment clutch lever is released or
unit damage or serious injury may
result.
4.
FRICTION DISC REPLACEMENT
1.
Place unit into service position.
7.
8.
Reconnect chute crank and secure with
spring clip. If equipped, reconnect remote
cap deflector cable and/or electric chute
wire harness.
2. Remove bottom cover by removing four
cap screws.
3. Place speed selector in first (1) position
and depress traction clutch lever to hold
friction disc and hub in position.
Replace belt cover.
4.
5.
6.
Remove cap screws from hub
(Figure 21).
Release traction clutch lever, shift to third
(3)
position, and remove friction disc.
Secure new friction disc on hub with five
cap screws and torque cap screws to
8-10
ft. lbs. (10,6-13,3 Nm).
7.
8.
Replace bottom cover.
Adjust traction drive clutch (see Traction
Drive Clutch Adjustment).
1
5
2
1. Cap Screw
2.
3.
4.
5.
6.
Friction Disc
Shift Arm
Idler Hex Shaft
Cotter Pin
Chain
4
3
6
Figure 21
OS0612
GB - 27
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 1024, Ariens 1028, Ariens 1128, Ariens 1332, Ariens 1336, Ariens 924116, Ariens 924117, Ariens 924300, Ariens 924505, Ariens 924506, Ariens 924508 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)