SPEED SELECTOR ADJUSTMENT ATTACHMENT CLUTCH/BRAKE
ADJUSTMENT
To adjust (Figure 16):
1.
2.
Place unit into service position.
Remove hair pin from adjustment pivot
pin.
(Figures 17 and 18)
WARNING: IMPROPER
3.
4.
5.
6.
Pull shift rod and pin out of speed selector
lever.
Place the speed selector in the fastest
reverse speed position.
Pull the shift rod straight up towards the
control panel as far as it will go.
Thread the adjustment pivot pin along the
shift rod until it aligns with the mating hole
on the speed selector lever. Insert the
pivot pin into hole.
Make sure the speed selector shifts into
each speed position.
Secure adjustment pivot pin with hairpin.
3
ADJUSTMENT could result in
unexpected movement of auger and
impeller causing death or serious
injury.
IMPORTANT: AUGER / IMPELLER MUST
STOP within 5 seconds when Attachment
Clutch/Impeller Brake lever is released.
Remove belt cover.
Check belt alignment (Figure 20).
Engine sheave and attachment pulley
must align vertically. Also, belt must be
centered in the idler pulley.
To align, move attachment pulley:
a.Loosen set screws.
1.
2.
7.
8.
b.Slide pulley and key to desired
position.
c.Tighten set screws.
Adjust cable slack.
3.
The clutch cable must be slack when the
lever is disengaged.
a.With clutch lever disengaged, loosen
jam nut on cable adjuster.
4
b.Turn adjuster body to remove all slack
from the cable. Do not stretch spring
or move lower clutch arm.
1
2
c.Turn back the adjuster body 5 turns
(approximately 1/4” or 6 mm). Finger
tighten jam nut.
d.Hold adjuster body with pliers and
tighten jam nut with wrench.
4.
Check spring length.
a.Measure the length of the clutch cable
spring.
1
. Shift Rod
2
. Adjustment Pivot Pin
3.
4.
Speed Selector Lever
Hairpin
b.Engage and hold the attachment
clutch lever.
c.Measure the length of the spring
again. The spring should be
Figure 16
OSs0193
3/16"
–7/16" (5–11 mm) longer when
the lever is engaged.
5.
Adjust spring length.
NOTE: Approximately 1/8" (3 mm) movement
of the idler will change spring extension by
1/8"
(3 mm).
a.Loosen the idler adjustment nut.
b.To increase spring extension, move
idler towards belt (Figure 20).
c.To decrease spring extension, move
idler away from belt.
GB - 24
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 1024, Ariens 1028, Ariens 1128, Ariens 1332, Ariens 1336, Ariens 924116, Ariens 924117, Ariens 924300, Ariens 924505, Ariens 924506, Ariens 924508 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)