Ariens Sno Thro 926016 17 21 22 23 926500 1 ST DLE DLET Snow Blower Owners Manual

Manual Start
IMPORTANT: DO NOT operate starter more than 15
seconds per minute, as overheating and damage can
occur. (If engine does not start, refer to
1.
2.
Turn discharge chute straight ahead.
Make sure that the traction clutch and attachment
drive clutch levers are fully disengaged.
TROUBLESHOOTING on page 31.)
11.
12.
13.
Adjust choke as needed.
3.
Push Primer Bulb 2 or 3 times for cold engine.
Disconnect power cord from outlet, then starter.
NOTE: When temperature is below -15° F (-26° C)
additional priming may be needed.
Set throttle to Part Throttle or Slow position for
adaptation to outside temperature or travel. Set
throttle to Fast position for normal operation.
4.
If engine is cold, apply choke. See Engine
Manual for detailed instructions.
Electric Start (12V)
NOTE: A warm engine requires less choking than a
cold engine.
1. Turn discharge chute straight ahead.
5.
6.
7.
Set throttle to proper starting position.
Turn on engine shut-off switch ("ON").
Insert key into ignition switch.
2. Make sure that the traction clutch and attachment
drive clutch levers are fully disengaged.
3.
Push Primer Bulb 2 or 3 times for cold engine.
NOTE: When temperature is below -15° F (-26° C)
additional priming may be needed.
12V - Turn key to RUN position.
120V - Push key into RUN position. DO NOT
twist key after it is inserted.
4.
If engine is cold, apply choke. See Engine
Manual for detailed instructions.
8.
9.
Grasp starter handle and pull rope out slowly until
it pulls harder. Let rope rewind slowly.
NOTE: A warm engine requires less choking than a
cold engine.
Pull rope with a rapid continuous full arm stroke.
Let rope rewind slowly.
5.
6.
Set throttle to proper starting position.
Turn ignition key to the START position until
engine starts and release into the RUN position.
IMPORTANT: DO NOT let Starter Handle snap against
Starter.
IMPORTANT: DO NOT operate starter more than 15
seconds per minute, as overheating and damage can
occur. (If engine does not start, refer to
10.
Repeat steps 7 and 8 until engine starts. (If
engine does not start, refer to
TROUBLESHOOTING on page 31.)
TROUBLESHOOTING on page 31.)
11.
12.
Adjust choke as needed.
7.
8.
Adjust choke as needed.
Set throttle to Part Throttle or Slow position for
adaptation to outside temperature or travel. Set
throttle to Fast position for normal operation.
Set throttle to Part Throttle or Slow position for
travel or adaptation to outside temperature. Once
achieved, set throttle to Fast position for normal
operation.
Electric Start (120V)
1.
Connect extension cord to starter.
Shut Off
IMPORTANT: Prevent damage to unit. Know voltage of
your starter and only use matching outlets.
1.
Release Traction Drive Clutch Lever and allow
unit to come to a complete stop.
2.
3.
4.
Plug extension into 120V 3-wire, grounded outlet.
Turn discharge chute straight ahead.
2.
Run Impeller a few minutes after use to prevent
freeze-up of Impeller.
Make sure that the traction clutch and attachment
drive clutch levers are fully disengaged.
3. Release Attachment Clutch Lever and wait for all
moving parts to come to a complete stop.
4.
5.
Move Throttle to the “Stop” position.
Turn off engine shut-off switch ("OFF").
5.
Push Primer Bulb 2 or 3 times for cold engine.
NOTE: When temperature is below -15° F (-26° C)
additional priming may be needed.
6. Remove key.
6.
Insert key into ignition switch on engine and push
into "Run" position. DO NOT twist key after it is
inserted.
SNOW REMOVAL
IMPORTANT: Allow unit and engine to adjust to the
outdoor temperature before clearing snow.
7.
If engine is cold, apply choke. A warm engine
requires less choking than a cold engine. See
Engine Manual for detailed instructions.
NOTE: Attachment clutch should be engaged before
wheel drive clutch when throwing snow.
8.
9.
Set throttle to proper starting position.
1. Select Speed Control position and direction.
2. Engage Attachment Clutch - Right Hand Lever.
3. Engage Traction Drive Clutch - Left Hand Lever.
Turn on engine shut-off switch ("ON").
Press starter button on engine until engine starts.
10.
GB - 18
Product Specification
CategoriesAriens Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , , , , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 36 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandAriens, Snow Blower
Document File TypePDF
Publisherariens.com
Wikipedia's PageAriens
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website