IMPORTANT: DO NOT overload unit capacity by
attempting to clear snow at too fast a rate. Use slow
speed to clear deep or hard packed snow.
2. 926016, 017, 500, 501: Press down on
handlebars enough to raise front of unit slightly
off surface.
926021, 022, 023: Place the unit in the transport
position (see Track Angle (926021, 022, 023) on
page 16).
Tips for Operation
Snow is best removed as soon as possible after snow
fall.
3.
Engage wheel or track drive clutch without
engaging attachment drive clutch.
To clear an area, run unit in an overlapping series of
paths. For large areas, start in the middle and throw
snow to each side, so snow is not cleared more than
once.
TRANSPORT
ALWAYS shut off engine, remove key, and close fuel
shut-off valve when transporting unit on a truck or
trailer.
ALWAYS direct snow away from area to be cleared and
with direction of the wind.
TRAVELING
Use extra care when loading or unloading unit onto
trailer or truck.
To travel from one work area to another:
Secure unit chassis to transport vehicle. NEVER
secure from rods or linkages that could be damaged.
1.
Set Throttle to Slow or Part-Throttle position.
DO NOT transport machine while engine is running.
MAINTENANCE
Ariens Dealers will provide any service or adjustments
which may be required to keep your unit operating at
peak efficiency. Should engine service be required,
contact an Ariens dealer or an authorized engine
manufacturer's service center.
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be performed on a
regular basis. More frequent service may be required.
MAINTENANCE SCHEDULE
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Service Performed
Each Use
Every 5
hrs.
Every 25
hrs.
Yearly
Check Dual Handle
Interlock
•
SERVICE POSITION
Check Fasteners
•
•
WARNING: Before tipping unit up onto
housing, remove fuel so no spills will occur
and remove battery (if equipped). Ensure unit
is secure and will not tip over during
maintenance.
Check Clutch
Operation
Check Clutch Spring
Adjustments
*
•
Clean Engine
•
•
Place unit on a flat level surface. Tip unit forward onto
front of auger housing for service. Ensure unit is secure
and will not tip over. Strap and clamp onto bench if
needed.
Check Engine Oil
Change Engine Oil
•
**
**
•
•
Check Tire Pressure
•
•
Check Auger
Gearcase
Service Position
General Lubrication
Battery Maintenance
•
•
•
•
*
After first five hours of operation.
**
926016, 017, 500, 501: After first two hours of
operation, thereafter every 25 hours. 926021, 022,
023: After first five hours of operation, thereafter every
50 hours.
OS7120
Figure 19
GB - 19
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 926016, Ariens 926017, Ariens 926021, Ariens 926022, Ariens 926023, Ariens 926500, Ariens 926501, Ariens ST11528DLE, Ariens ST11528DLET, Ariens ST1332DLE, Ariens ST1332DLET, Ariens ST1336DLE, Ariens ST9526DLE, Ariens ST9526DLET |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)