3
2
1
3
5
4
Figure 8
OS7271
1.
2.
3.
4.
5.
Cable Anchor
Cable End
Deflector Cable
Cable Fitting
Cable Bracket
10.
Replace the gear cover removed in step 4.
IMPORTANT: Rotate the discharge chute to the left
when tightening the pedestal hardware to ensure
clearance between the discharge chute and the belt
cover.
Figure 9
OS7070
Connect Battery (926023, 500, 501)
11.
Tighten pedestal hardware to 15 – 31 lbf-ft (20 –
1.
2.
3.
Remove wing nuts from battery cover.
Install wire lead to battery terminal.
42
N•m).
12.
Make sure the discharge chute rotates left and
right when you push the discharge chute control
lever left and right.
Install battery cover and tighten wing nuts.
Check Function of Dual Handle Interlock
Deflector Remote
Without the engine running, press down (engage) both
clutch levers. Release attachment clutch lever.
Attachment clutch should remain engaged until traction
clutch lever is released, then both clutches must
disengage. If they do not, contact your Dealer for
repairs.
Connect the cable end to the cable anchor on the
discharge deflector before clipping the cable to the
cable bracket on the discharge chute.
1.
2.
3.
Route deflector remote cable along the left side of
the chute pedestal.
Check Tire Pressure (926016, 017, 500, 501)
Insert the barrel on the cable end into the bracket
on left side of chute deflector (Figure 9).
Check tire pressure and adjust to the pressure listed on
tire sidewall.
Hold seal out of the way while routing the cable
through the bracket on the left side of the
discharge chute, and then push the cable fitting
into the bracket.
CAUTION: Avoid injury! Explosive separation
of tire and rim parts is possible when they are
serviced incorrectly:
4.
5.
Push the seal securely over the end of the cable
fitting to prevent water from entering the cable.
•
Do not attempt to mount a tire without
the proper equipment and experience to
perform the job.
Check deflector travel. Adjust nut on cable end
under handlebar to obtain full travel, if necessary.
•
•
Do not inflate the tires above the
recommended pressure.
Do not weld or heat a wheel and tire
assembly. Heat can cause an increase
in air pressure resulting in an explosion.
Welding can structurally weaken or
deform the wheel.
•
Do not stand in front or over the tire
assembly when inflating. Use a clip-on
chuck and extension hose long enough
to allow you to stand to one side.
GB - 9
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 926016, Ariens 926017, Ariens 926021, Ariens 926022, Ariens 926023, Ariens 926500, Ariens 926501, Ariens ST11528DLE, Ariens ST11528DLET, Ariens ST1332DLE, Ariens ST1332DLET, Ariens ST1336DLE, Ariens ST9526DLE, Ariens ST9526DLET |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)