6
7
1.
2.
3.
4.
5.
Traction Belt Idler
Cap Screw
Belt Finger
Traction Drive Belt
Attachment Belt
Idler
4
3
6.
Attachment Drive
Belt
7.
8.
9.
Engine Sheave
Attachment Pulley
Attachment Idler
Adjustment Nut
2
1
8
9
5
Figure 24
OS3320
8. Remove attachment drive belt from
attachment pulley (hold brake away from
belt).
8. Replace belt cover.
TRACTION DRIVE BELT
REPLACEMENT
Install new attachment drive belt:
NOTE: Housing and frame must be tipped
apart and attachment drive belt removed from
engine sheave in order to change traction
drive belt.
1. Remove attachment drive belt (see
Attachment Drive Belt Replacement).
1. Place new attachment belt onto
attachment pulley.
2. Tip housing and frame back together and
secure with cap screws.
3. Place belt onto engine sheave.
2. Pull idler away from traction drive belt and
remove belt from idler pulley, engine
sheave and driven pulley (it may be
necessary to turn engine pulley using
recoil handle).
4. Make sure engine sheave and attachment
pulley align. If alignment is necessary,
loosen attachment pulley set screws,
reposition pulley and retighten set
screws.
NOTE: To gain clearance, engage traction
clutch and if necessary pull back attachment
idler arm clevis pin.
3. Install new traction drive belt onto
attachment pulley and engine sheaves.
5. Reposition and secure belt fingers.
IMPORTANT: Make sure belt fingers are
1/16
in. to 1/8 in. (1.6-3mm) from belt when
attachment clutch is engaged.
6. Check adjustment. See Attachment
4. Replace attachment drive belt (See
Replace Attachment Drive Belt).
Clutch/Brake.
FRICTION DISC REPLACEMENT
WARNING: AUGER / IMPELLER
MUST STOP within 5 seconds when
attachment clutch lever is released or
unit damage or serious injury may
result.
1. Place unit into service position.
2. Remove bottom cover by removing four
cap screws.
3. Place speed selector in first (1) position
and depress traction clutch lever to hold
friction disc and hub in position.
7. Reconnect chute crank and secure with
spring clip. If equipped, reconnect remote
cap deflector cable and/or electric chute
wire harness.
4. Remove cap screws from hub
(Figure 25).
GB - 26
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 924124, Ariens 924125, Ariens 924126, Ariens 924127, Ariens 924128, Ariens 924335, Ariens 924336, Ariens 924337, Ariens 924338, Ariens 924516, Ariens 924517, Ariens ST11526DLE, Ariens ST11528DLE, Ariens ST11528LE, Ariens ST1332DLE, Ariens ST1332LE, Ariens ST1336DLE, Ariens ST1336DLE Ariens 924124, Ariens ST926DLE |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)