SB2040Snowblower
Assembly and Installation
Discharge Chute Assembly
1.
Install the discharge guard on the chute as shown using two 3/8-3/4" hex bolts, 3/8" flat washers,
3/8" lock washers and 3/8" hex nuts.
2.
Place the antifriction ring onto the blower head; the ring is keyed to the blower head so only one
position fits.
3.
4.
Apply a generous amount of general purpose grease to the top lip of the antifriction ring.
Install the long (1-11/16") plastic bushing into the worm gear bracket. Apply grease to the inside
surface of the bushing.
DISCHARGE GUARD
3/8"
3/8"
HEX NUT (2)
LOCK WASHER (2)
1/4" x 3/4"
HEX BOLT (2)
-
RETAINING PLATE (3)
3/8" FLAT WASHER (2)
1/4" X 3/4" HEX BOLT (6)
1-5/16'' PLASTIC BUSHING
WORM GEAR
1/4" HEX NUT (6)
5.
Grease the inside of the shorter (1-5/16") plastic bushing then slide it onto the short shaft of the worm
gear. Grease the long shaft on the worm gear, and install it into the bushing on the worm gear bracket.
6.
7.
8.
Position the chute on the blower head. Get a helper to hold it in place if needed.
Install the two front retaining plates using four 1/4 x 3/4" hex bolts, lock washers and hex nuts.
Install the short shaft of the worm gear (with bushing) into the
bracket on the blower head.
3/4" HEX BOLT
9.
Use the 1/4 x 3/4" hex bolts to install the left rear retaining plate
along with the crank handle bracket.
10.
Apply a generous amount of general purpose grease to the worm
gear and chute gear teeth.
11.
Use the longer, 1/4 x 3/4" hex bolts to secure the right rear
retaining plate, hold-down bracket, and the plastic chain cover.
1/4" L
" HEX NUT
1/4
POP 52152 (9610)
13
| Categories | Honda Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Honda SB2040 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Honda, Snow Blower |
| Document File Type | |
| Publisher | hondapowerequipment.com |
| Wikipedia's Page | Honda |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)