Removing the Snowblower
SB2040 Snowblower
Removing the Snowblower
1.
Make sure the PTO clutch lever is OFF.
2.
Drive the lawn tractor to a flat, level surface, turn the engine off, remove the ignition key and set the
parking brake ON. Disconnect the spark plug cap. Lower the height adjustment lever all the way down.
3.
4.
Raise the front tires and support them squarely on top of two 4 x 4" blocks of wood.
SILVER
DRIVE BELT
Remove the silver-colored bolt that holds the
engine pulley belt guard to the right side of the
lawn tractor frame. Allow the belt guard to fall
down slightly, then remove the snowblower
drive belt from the engine pulley.
BELT GUARD
PIVOT PLATE ON
U-SHAPED BRACKET
5.
Loosen the jam nut on the belt tension
turnbuckle, then lengthen the turnbuckle
enough to disconnect the J-bolt from the PTO
pivot plate.
FRONT
LOOSEN JAM NUT
REMOVE HOOK BOLT
6.
Remove the 2 x 40 mm spring clip and two flat
washers from the PTO connecting rod where it
is connected to the PTO pivot plate. Allow the
rod to fall clear from the pivot plate. Retain the
spring clip and washers when reinstalling the
snowblower or the mower deck.
FLAT WASHER (2)
and
2x26mm
SPRING CLIP
30
POP 52152(9610)
| Categories | Honda Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Honda SB2040 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Honda, Snow Blower |
| Document File Type | |
| Publisher | hondapowerequipment.com |
| Wikipedia's Page | Honda |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)