SB2040 Snowblower
5/16''
LOCK
5/16"
HEX BOLT (4
L-SHAPED BRACKET ON
Install Brackets
1.
If already installed, remove the hardware and
the I-shaped brackets from the subframe of the
assembled snowblower.
2.
Install the I-shaped brackets to the lawn tractor
frame using two 5/16 x 3/4" bolts and 5/16" lock
washers as shown. Make sure the I-shaped
brackets are installed on the outside of the
lawn tractor frame.
3.
Remove the u-shaped bracket and hardware
from the subframe.
L-SHAPED BRACKET ON
RIGHT SIDEOF TRACTOR FRAME
4.
5.
Loosely install (don't tighten) the u-shaped
bracket to the two I-shaped brackets using four
3/8
x 1"hex bolts and 3/8" lock washers.
Raise the height adjustment lever as far as
possible.
3/8
x 1" HEX BOLT (4)
Install the Snowblower
1.
Position the snowblower assembly directly in
front of the lawn tractor. Raise and support the
blower head, then slide the snowblower
assembly user the lawn tractor so the
subframe holes are about 1/4" further back
from their corresponding holes in the u-shaped
bracket.
SPRING CLIP (2)
FLAT WASHER (2)
from MOWER DECK
2.
3.
Lower the height adjustment lever all the way
down.
Connect the lift plates to the rear lift arms on
the lawn tractor using the same spring clips
and flat washers used for the mower deck.
LIFTING ARM (2)
(on lawn tractor frame)
POP 52152(9610)
15
| Categories | Honda Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Honda SB2040 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Honda, Snow Blower |
| Document File Type | |
| Publisher | hondapowerequipment.com |
| Wikipedia's Page | Honda |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)