4
Controls and Features
Shift Lever
Drive Control
Chute Directional Control
Auger Control
Gas Cap
Chute Assembly
Oil Fill
Heated Grips*
Clean Out
Tool
Muer
Recoil Starter
Handle
Primer
Ignition
Key
Throttle
Control
Choke
Control
Electric Start
Button
Electric Starter Outlet
Augers
Oil Drain
Skid Shoe
Figure 4-1
Snow thrower controls and features are described below and
illustrated in Fig. 4-1.
Choke Control
The choke control is found on the rear of
the engine and is activated by rotating the
knob. Activating the choke control closes
the choke plate on the carburetor and aids
in starting the engine.
Shift Lever
The shift lever is located in the right side of the
handle panel and is used to determine ground
speed and direction of travel.
Ignition Key
Forward
The ignition key is a safety device. It must
be fully inserted in order for the engine to
start. Remove the ignition key when the
snow thrower is not in use.
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (1) is the
slower and two (2) is the faster.
Note: Do not turn the ignition key in an
attempt to start the engine. Doing so may
cause it to break.
11
Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | MTD 600 Series, MTD Snow Blower Manual |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | MTD, Snow Blower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)