MTD 600 Series K Style Snow Blower Owners Manual

6
.
Slip the drive belt off the pulley and between  friction
wheel and friction wheel  disc. See Fig. 8-7.
Friction Wheel Removal
If the snow thrower fails to drive with the drive control engaged,
and performing the drive control cable  adjustment fails to
correct the problem, the friction  wheel may need to be replaced.
Follow the instructions below. Examine the  friction wheel for
signs of wear or cracking and replace if necessary:
1.
Allow the engine to run until it is out of fuel.
2
.
.
Place the shift lever in third Forward (F3) position.
3
Carefully pivot the snow thrower up and forward  so that it
rests on the auger housing.
4
.
Remove the frame cover from the underside of  the snow
thrower by removing four self-tapping screws which secure
it. Remove the right-hand wheel by removing the screw
and bell washer which secure it to the axle.  See Fig. 8-8.
Figure 8-7
7.
Remove and replace belt in the reverse order.
NOTE: Engaging the drive control will ease reassembly of
the belt.
Figure 8-8
sectiOn 8 — service
23
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website