MTD 600 Series K Style Snow Blower Owners Manual

5.
Carefully remove the hex nut which secures the  hex shaft
to the snow thrower frame and lightly tap the shaft’s  end to      components. If you’re disassembling the friction  wheel and
Follow the previous steps in reverse order to reassemble
dislodge the ball bearing from the right side  of the frame.
replacing only the rubber ring, proceed  as follows:
See Fig. 8-9.
1.
Remove the four screws which secure the friction  wheel’s
side plates together. See Fig. 8-11.
NOTE: Be careful not to damage the threads on the shaft.
Figure 8-9
Figure 8-11
6
.
Carefully position the hex shaft  downward and to the left
before carefully sliding the friction  wheel assembly off the
shaft. See Fig. 8-10.
2.
Remove the rubber ring from between  the plates.
Reassemble the side plates with a new rubber  ring.
3.
NOTE: When reassembling the friction wheel  assembly,
make sure that the rubber ring is centered and seated
properly between the side  plates. Tighten each screw
only one rotation before turning the wheel  clockwise
and proceeding with the next  screw. Repeat this process
several times to ensure the plates are secured with equal
force (between 6 ft-lbs and 9 ft-lbs).
NOTE: If you’re replacing the friction wheel  assembly as a
whole, discard the worn part and slide  the new part onto
the hex shaft.
4
.
Slide the friction wheel assembly  back onto the hex shaft
and follow the steps above in reverse order to reassemble
components.
Figure 8-10
24
sectiOn 8 — service
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website