MTD 600 Series K Style Snow Blower Owners Manual

3
Assembly & Set-Up
Contents of Carton
One Snow Thrower
Two Replacement Auger Shear Pins
One Product Registration Card
One Snow Thrower Operator’s
Manual
Assembly
Handle
1.
Place the shift lever in the Forward-6  position
2
.
Observe the lower rear area of the snow thrower to be sure
both cables are aligned with roller guides  before pivoting
the handle upward. See Fig. 3-1.
Figure 3-2
Figure 3-1
NOTE: Make certain the upper ends of each cable  are
seated properly in its bracket.
3.
Secure the handle by tightening the plastic knob  located
on both the left and right sides of the  handle. Remove
and discard any rubber bands, if present.  They are for
packaging purposes only.
Chute Assembly
1.
Removewing nutandhex  screwfrom chutecontrolassembly
and clevis pin and cotter pin from chute support  bracket.
Position the chute assembly (forward-facing) over the
chute base. See Fig. 3-2.
Figure 3-3
2
.
Place chute assembly onto chute base and secure chute
control assembly to chute support bracket with  clevis pin
and cotter pin removed earlier. See See Fig. 3-3.
7
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website