MTD 600 Series K Style Snow Blower Owners Manual

3.
Remove the belt from around the auger pulley, and slip the        Drive Belt
belt between the support  bracket and the auger pulley.
To remove and replace your snow thrower’s drive belt, proceed
as follows:
See Fig. 8-5.
1.
Place a piece of plastic under the gas cap.
2
.
Remove the plastic belt cover on the front of the engine  by
removing the two self-tapping screws.  Refer to Fig. 8-1.
3.
Remove the belt as follows. See Fig. 8-6.:
a.      Roll the auger belt off  the engine pulley.
b.      Use a wrench to pivot the idler pulley toward the
right.
c.      Lift the drive  belt off engine pulley
Figure 8-5
4
.
Reassemble auger belt by following instructions  in reverse
order.
NOTE: Do not forget to reinstall the shoulder screw
and reconnect the spring to the frame  after installing a
replacement auger belt.
Figure 8-6
4
.
.
Carefully pivot the snow thrower up and forward  so that it
rests on the auger housing.
5
Remove the frame cover from the underside of  the snow
thrower by removing four self-tapping screws which secure
it. Refer to Fig. 8-3.
22
sectiOn 8 — service
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website