MTD E662H E642E 614E E644E E664F E6A4E Snow Blower Owners Manual

Auger
Drive
Clutch
Auger
Drive
Clutch
Traction Drive
Clutch
Traction
Drive
Clutch
Shift
Lever
Shift
Lever
Chute
Crank
Chute
Crank
Models 642 and 662
Models 614, 644, 664, and 6A4
Figure 22  
Figure 23  
SECTION 7:  OPERATION
BEFORE STARTING
WARNING: Observe all Warning Labels
on  the  snow  thrower  prior  to  use.  See
Figure 1.
Metal Loop
on Spark
Plug Wire
Your snow thrower is shipped with oil; however,
you must check the oil level before operating. Be
careful not to overfill.
Rubber Boot
Figure 24  
3.
4.
Make  certain  the  auger  and  drive  clutch  levers
are in the disengaged (released) position.
The  spark  plug  wire  was  disconnected  for  safety.
Attach spark plug wire to spark plug before starting
Move throttle control up to FAST position. Insert
ignition key into slot. See Figure 21. Be certain it
snaps into place. Do not turn key.
GAS AND OIL FILL-UP
Check oil level and add oil if necessary. Service the
engine  with  gasoline  as  instructed  in  the  separate
engine  manual   packed   with  your   snow  thrower.
Read instructions carefully.
ENGINE   WILL  NOT   START
UNLESS IGNITION KEY IS IN-
SERTED
INTO
IGNITION
SLOT
COVER. DO NOT TURN IGNI-
TION KEY.
IN
CARBURETOR
WARNING: Never
fill
fuel
tank
indoors,  with  engine  running  or  while
engine is hot. Do not smoke when filling
fuel tank.
Electric Starter: (If Equipped)
TO START ENGINE
WARNING: The    electric    starter    is
equipped  with  a  three-wire  power  cord
and plug, and is designed to operate on
NOTE: If  unit  shows  any  sign  of  motion  (drive  or
augers)   with   the  clutch   grips   disengaged,   shut
engine off immediately. Readjust as instructed in the
120
volt AC household current. It must
be  properly   grounded  at  all   times  to
avoid  the  possibility  of  electric  shock
which may be injurious to the operator.
Follow  all  instructions  carefully.  If  the
house wiring system is not a three-wire
grounded   system,    do   not   use    this
electric starter under any conditions.
Final
ASSEMBLY INSTRUCTIONS.
Adjustments
section
of
SECTION
5:
1.
Attach  spark   plug  wire   to  spark  plug.   Make
certain the metal loop on end of the spark plug
wire (inside the boot) is fastened securely over
the metal tip on the spark plug. See Figure 24.
2.
Make certain the fuel cutoff valve is in the OPEN
(vertical) position. See Figure 20.     
12
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website