MTD E662H E642E 614E E644E E664F E6A4E Snow Blower Owners Manual

AUGER BELTS
5.   Roll the front and rear auger belts off the engine
pulley. See Figure 30.
NOTE: It  is   necessary  to  remove   both  belts  in
order to change either one. If changing just one belt,
be certain to check the condition of the other belt.
6.
Unhook the idler spring from the hex bolt on the
auger housing. See Figure 31.
7.
Back out the stop bolt to allow the belts to slip
between the bolt and auger pulley.
See Figure 32.
1.
Remove the plastic belt cover on the front of the
engine by removing the two self-tapping screws.
See Figure 29.
8.
9.
Lift  the  rear  auger  belt  from  the  auger  pulley,
and  slip  belt  between  the  support  bracket  and
the  auger  pulley.  See  Figure  31.  Repeat  this
step for front auger belt.
2.
3.
Drain  the  gasoline  from  the  snow  thrower,  or
place a piece of plastic under the gas cap.
Tip the snow thrower up and forward so that it
rests on the auger housing.
Replace  both   auger   drive  belts   by  following
instructions in reverse order.
DRIVE BELT
1.
Follow    steps     1    through    4     of    previous
instructions.
2.
Pull idler pulley up, and lift belt off engine pulley,
idler pulley, and friction wheel disc.
See Figure 30.
Self-Tapping
Screws
Belt
Cover
3.   Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 32.
4.
Slip   belt  between   friction  wheel   and   friction
wheel disc. See Figure 31. Remove and replace
belt.  Reassemble  following   the  instructions  in
reverse order.
NOTE: The support bracket must rest on the stop
bolt  after  the  new  belt  has  been  assembled.  See
Figure 32.
Figure 29  
4.
Remove six self-tapping screws from the frame
cover underneath the snow thrower.
Friction
Wheel
Drive
Rear
Auger
Belt
Belt
Engine
Pulley
Front
Auger
Belt
Support
Bracket
Rear
Auger
Belt
Frame
Engine
Pulley
Idler
Pulley
Idler
Pulley
Figure 30  
Front
Auger
Pulley
Support
Bracket
Spring
Auger
Pulley
Auger
Housing
Idler
NOTE: It may be necessary to loosen the six hex
nuts  that  fasten  the  frame  to  the  auger  housing  to
aid in belt removal.
Spring
Figure 31  
17
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website