ASSEMBLY INSTRUCTIONS
7.
Tighten the clamp screws evenly, until the J-handle is
secure.
KNOW YOUR UNIT
INSTALLING THE CUTTING SHIELD
Spark Plug Oil Fill
Plug
WARNING:
Never operate the trimmer without
Muffler
the cutting attachment shield in place to prevent
serious personal injury.
On/Off Stop
Control
Starter
Rope
Grip
Fuel Cap
Choke Lever
Use the following instructions if the cutting attachment shield
on your unit is not installed or if you ever need to re-install it.
1.
Place the cutting attachment shield onto the shaft housing
above the clamp assembly (Fig. 3).
Shaft Grip
Clamp
J-Handle
Throttle
Control
Primer
Bulb
Air Filter
Cover
Hanger
EZ-Link™
Recessed Pocket
Shaft
Cutting Attachment
Shield
Gear
Housing
Cutting Attachment
Shield
Height
Blade
Shield
Fig. 3
Adjustment
Wheel
2.
Push the cutting attachment shield down to the top of the
cutting attachment assembly. Then rotate the shield until
its screw holes line up with the holes in the cutting
attachment. The shield guard should fit into the recessed
pocket (Fig. 3).
Line
Cutting
Blade Edger Blade
Cutting Attachment
On some units, the J-handle may be pre-installed. In this case
you must loosen screws and adjust the handle to fit the operator.
Go to step 5 if the J-handle is pre-installed.
(4) Screws
INSTALL AND ADJUST THE J-HANDLE
1.
Place the J-handle between the top and middle clamp
pieces (Fig. 1).
(4)
Screws
J-Handle
2.
While holding the three
pieces together, install
the four (4) screws
through the top clamp
and into middle clamp.
Top Clamp
NOTE: The holes in the top
and middle clamp
will line up only
when assembled
correctly.
Middle Clamp
Bottom Clamp
Fig. 4
Nuts
3.
Install the screws with a Phillips screwdriver (Fig. 4).
Fig. 1
3.
4.
Place the clamps and
the J-handle over the
shaft housing and onto the bottom
clamp.
Hold each hex nut in the bottom
clamp recess with a finger. Start
screws with a large Phillips
WARNING:
To avoid serious personal injury, the
cutting attachment shield MUST be in place at all
times while operating the unit as a trimmer.
Decal
screwdriver. Do not tighten until
you make the handle adjustment.
Fig. 2
5.
6.
Slide the J-handle in or out until the
arrow/white line on the decal touches the clamp assembly
(Fig. 2). You must first loosen the screws if the handle is
pre-installed.
While holding the unit in the operating position (Fig. 15),
position the J-handle to the location that provides you the
best grip.
4
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, MTD Trimmer Manuals, Trimmer Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD TB525ET, Troy-Bilt TB525ET |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)