STIHL BT 120 C Auger Owners Manual

English / USA
Motor Management
Adjusting the Carburetor
Carburetor with LD Screw
General Information
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
Your carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
LD+-
Standard Setting
:
:
Shut down the engine.
:
Carefully screw the idle speed
screw (LD) down onto its seat
counterclockwise(left-hand thread).
Then open it two turns clockwise.
Remove the auger from the
machine.
:
:
Check air filter and clean or replace
as necessary.
Check that the throttle cable is
properly adjusted and readjust if
necessary – see chapter on
"Adjusting the Throttle Cable".
Adjusting Idle Speed
:
:
Carry out standard setting.
Start and warm up the engine.
BT 120 C
19
Product Specification
CategoriesAuger Drill Manuals, Stihl Auger Drill Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 66 pages
Document TypeOperator's Manual
LanguageEnglish, Español
Product BrandSTIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Auger
Document File TypePDF
Publisherstihl.com
Wikipedia's PageStihl
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website