English / USA
Fuel Mix
Never remove fuel filler cap while engine
is running.
Fold the grip flush with the
top of the cap. If the grip
does not lie completely
Your STIHL power drill uses an oil-
gasoline mixture for fuel (see the
chapter on "Fuel" in your owner's
manual).
Select bare ground for fueling and move
at least 10 feet (3 m) from the fueling
spot before starting the engine.
flush with the cap and the
detent on the grip does
not fit in the
!
Warning!
Check for fuel leakage while refueling
and during operation. If fuel or oil
corresponding recess in the filler neck,
the cap is not properly seated and
tightened and you must repeat the
above steps.
Gasoline is an extremely
leakage is found, do not start or run the
engine until leak is fixed and spilled fuel
has been wiped away. Take care not to
get fuel on your clothing. If this happens,
change your clothing immediately.
flammable fuel. Use
extreme caution when
handling gasoline or fuel
mix. Do not smoke or
bring any fire or flame
Operating the power drill
The power drill should be operated by
one person.
near the fuel.
!Warning!
In order to reduce the risk of fuel spillage
and fire from an improperly tightened
fuel cap, correctly position and tighten
the fuel cap in the fuel tank opening.
To reduce the risk of injury from reactive
forces, the operator must have a firm
grip on the machine and a good foothold
before the throttle is opened to start the
power drill.
Fueling Instructions
Fuel your power drill in well-ventilated
areas, outdoors only.
To do this with the STIHL
cap on this machine, raise
Always shut off the engine and allow it to
cool before refueling.
the grip on the top of the
Gasoline vapor pressure may build up
inside the gas tank of a two cycle engine
depending on the fuel used, the weather
conditions, and the venting system of
the tank. In order to reduce the risk of
burns or other personal injury from
escaping gas vapor and fumes, remove
the gas cap on the STIHL product
cap until it is upright at a
90° angle. Insert the cap
into the fuel tank opening
with the triangular marks on the grip of
the cap and on the fuel tank opening
lined up. Using the grip, turn the cap
firmly clockwise as far as it will go
(approx. a quarter turn).
carefully so as to allow any pressure
build-up in the tank to release slowly.
6
BT 45
| Categories | Auger Drill Manuals, Stihl Auger Drill Manuals |
|---|---|
| Tags | STIHL BT 45 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Auger |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)