English
Loop handle without barrier bar
Securing the loop handle
Adjusting the Throttle
Cable
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
8
7
8
7
4
Adjust the throttle cable only after the
unit is fully assembled – the control
handle must be in the normal operating
position.
A
9
4
10
3
1
5
6
1
N
Use a suitable tool to push the slide
to the end of the slot (see
illustration).
N
Fit the clamp (3) in the loop
handle (4) and place them both on
the drive tube (5).
N
Secure the loop handle (4) about
20cm/8in (A) forward of the control
handle (9).
N
N
N
Place the clamp (6) in position.
Line up the holes.
N
N
Line up the loop handle.
Tighten down the screws firmly –
lock the nuts if necessary.
STOP
Fit washers (7) on the screws (8)
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
The sleeve (10) (not fitted on all models)
must be between the loop handle and
the control handle.
2
1
N
Go to "Securing the loop handle".
N
Press down the throttle trigger
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
1
6
FS 110, FS 110 R
| Categories | Blower Vacuum and Sweeper Manuals, STIHL Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL FS 110 |
| Download File |
|
| Language | English, Français, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Trimmer |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)