English
Rule of thumb:
Engine stops while idling
Spark Arresting Screen in
Muffler
Turn the high speed screw (H) about
one quarter of a turn for every 1000 m
N
Turn the idle speed screw (LA)
slowly clockwise until the engine
runs smoothly – the cutting
attachment must not move.
(3300
ft) change in altitude.
In some countries the muffler is
equipped with a spark arresting screen.
Conditions for adjustment
N
If the engine is down on power,
check the spark arresting screen in
the muffler.
N
Carry out the standard setting
without disturbing the high speed
screw (H).
Cutting attachment runs when engine
is idling
N
Turn the idle speed screw (LA)
counterclockwise until the cutting
attachment stops running and then
turn the screw about another 1/2 to
N
N
Wait for the muffler to cool down.
N
N
Warm up the engine for about 3
minutes.
Move the slide control to STOP-0.
Open the throttle wide.
3/4
turn in the same direction.
At high altitude
Turn the high speed screw (H)
clockwise (leaner), no further than
stop, until there is no further
noticeable increase in engine
speed.
If the working tool or cutting
attachment continues to run when
the engine is idling, have your
machine checked and repaired by
your servicing dealer.
1
Take out the screw (1).
3
N
Erratic idling behavior, engine stops
even though setting of LA-screw has
been corrected, poor acceleration
At sea level
Turn the high speed screw (H)
N
N
Idle setting is too lean
counterclockwise (richer), no further
than stop, until there is no further
noticeable increase in engine
speed.
N
Turn the low speed screw (L)
counterclockwise, no further than
stop, until the engine runs and
accelerates smoothly.
It is possible that maximum engine
speed may be reached with the standard
setting.
Erratic idling behavior
2
2
Idle setting is too rich
Adjusting Idle Speed
N
Take out the screws (2) and remove
the shroud (3).
N
Turn the low speed screw (L)
clockwise, no further than stop, until
the engine runs and accelerates
smoothly.
It is usually necessary to change the
setting of the idle speed screw (LA) after
every correction to the low speed
screw (L).
N
Warm up the engine for about 3
minutes.
3
0
FS 110, FS 110 R
| Categories | Blower Vacuum and Sweeper Manuals, STIHL Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL FS 110 |
| Download File |
|
| Language | English, Français, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Trimmer |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)