ELECTRIC START SYSTEM (12 VOLT)
Starter Assembly
5. Reassemble pinion/clutch assembly. Apply a small
amount of Lawn-Boy “AX” grease to the pin. Slide
the assembly on to the pin with the drag spring (A)
1.
2.
3.
Apply a light coat of Lawn-Boy “AX” grease to the
pinion gear, thrust washer, and driven gear prior to
installation.
over the stud. (See Figure 102.)
A
Place the pinion gear on small driveshaft in motor
housing with either side facing up. (See Figure
101.)
Place the thrust washer then the driven gear on the
pin. Make sure the raised side of the driven gear is
facing the cover plate.
Figure 102
1657.020
Starter Installation
1.
2.
Install the starter leaving the bolts loose.
Using a feeler gauge, gap the end of the pinion/
clutch assembly away from the engine .019” to
.021”
(48 mm to .53 mm). While keeping this air
gap, tighten the Allen head bolt first, then the lower
mounting bolt.
Figure 101
1657-013.tif
4.
Install the cover plate with the word “OUT” facing
the pinion/clutch assembly and secure with two
screws and drag spring stud. Make sure you
replace the drag spring stud in its original position.
Torque screws and stud to 20 in. lbs.
3. Plug the wiring connector in and install the shrouds
and fuel tank.
55
Categories | Lawn Mower Manual, Lawn-Boy Lawn Mower Manuals, Toro Lawn Mower Manual |
---|---|
Download File |
|
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)