Checking and Adjusting the Blade Level
Adjusting Front-to-Rear Pitch
Each of the three XL cutting units has a slightly
different specification for front-to-rear pitch and slight
variations in the adjustment process. Each cutting unit
is covered separately in one of the following
subsections.
32-inch (81.3cm) Cutting Unit
The blade on this model should be 1/4-5/8 inch
(6-16mm) lower in front. If the pitch is outside this
range adjustment is necessary (Figure 39).
Figure 40
XL32pit2.TIF
Hairpin cotter and
1.
2.
Adjusting block
Long rod
3.
washer
Mower mount
4.
3.
4.
Check the front-to-rear pitch again. If the front is
still out of specification proceed to step 4.
Otherwise, recheck the side-to-side level to
ensure it did not change.
Adjust the front-to-rear pitch by rotating the
special pitch adjusting nuts on both sides of the
mower pivot mount (Figure 41).
Figure 39
Measure rear center
XL32pit1.TIF
1.
Measure front center
2.
1.
2.
Verify that the side-to-side level is correct. If not
adjust that first.
Measure the length of the rod extending out of the
front of the adjusting block on the sides of the
chassis (Figure 40). If the rod length is not
5/8
inch (16mm), remove the hairpin cotter and
washer from the end of the rod and turn the rod
until the 5/8 inch (16mm) dimension is obtained.
Then install the end of the rod into the hole in the
mower mount and secure it in place with the
washer and hairpin cotter. Repeat this process on
the other side of the mower.
Figure 41
XL32pit3.TIF
Bolt and locknut
1.
Pitch adjusting nut (left)
2.
3.
A = Down to raise mower
B = Up to lower mower
Mower pivot mount
Service Dealer’s Guide to Great Quality of Cut
4 - 11
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Model Year | 2002 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Toro Lawnmower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Product Type | Walk Behind Mower |
| Engine Manufacturer | Briggs & Stratton |
| Engine Motor Type | 2 Cycle, 2 Cycle CARB1, 2 Cycle EPA1, 2 Cycle EPA2, 4 Cycle |
| Transmission Type | Hand Push |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)