Checking and Adjusting the Blade Level
38- and 44-inch (96.5 and 111.7cm) Cutting Units
To check for a bent spindle, remove the belt and spin
the blade spindle. Look at the center; if it rotates in a
tight circle, the spindle is not bent. If the center appears
to wobble, the spindle is bent and should be replaced.
On mowers with multiple blades, not only do the blades
need to be a minimum of 1/8 inch up from the bottom
edge of the housing, but they must also line up where
the tips come together. Take the two blade tips and
point them towards each other. They must be within
1/8-3/16 inch of level with each other, or both must be
the same distance from the blade to the ground
(Figure 48).
Yet another way to check this with the blades attached
is to align the blades (two blades at a time on three
blade mowers), then run a string across the cutting tips
of the blades. The string should be straight. If it is not,
the blade or spindle could be bent.
If the saddles or blades do not line up and the spindles
are not bent, a shim between the spindle housing and
the mower housing may help align them. Loosen the
spindle to mower housing bolts and insert shim
washers until the saddles are in line (Figure 50). Then,
if you used washers to shim the spindle housing,
remove the bolt and reassemble through the washer to
secure it.
Figure 48
XL2bS2S.TIF
1.
2.
Blade side to side
3.
Measure here
Outside cutting edges
An alternate way to check this is to remove the mower
housing and turn it over. Remove both blades and lay a
straight edge on both blade saddles (Figure 49). It
should lie flat. If not, either the spindle or the housing
where the spindle mounts may be bent.
Figure 50
MVC-732X.JPG
Figure 49
altbltrk.TIF
Service Dealer’s Guide to Great Quality of Cut
4 - 15
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Model Year | 2002 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Toro Lawnmower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Product Type | Walk Behind Mower |
| Engine Manufacturer | Briggs & Stratton |
| Engine Motor Type | 2 Cycle, 2 Cycle CARB1, 2 Cycle EPA1, 2 Cycle EPA2, 4 Cycle |
| Transmission Type | Hand Push |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)