Checking and Adjusting the Blade Level
Adjusting Blade Tracking
washers to shim the spindle housing, remove the bolt
and reassemble through the washer to secure it.
On mowers with multiple blades, not only do the blades
need to be a minimum of 1/8 inch up from the bottom
edge of the housing, but they must also line up where
the tips come together. Take the two blade tips and
point them towards each other. They must be within
1/8-3/16 inch of level with each other, or both must be
the same distance from the blade to the ground
(Figure 62).
5xi Series Tractors
Figure 62
trclevel.TIF
1.
Measure here
Another method is to remove the blades and place a
straight edge between the blade saddles (Figure 63).
They should be in line. If they are not, loosen the bolts
securing the spindle housing to the mower housing.
Insert shim washers and recheck. Once you have the
alignment, remove the bolt and reinstall through the
spindle housing, washer, and mower housing to secure
the shim.
Figure 64
0757-01-2.TIF
Adjusting Side-to-Side Level
All mower attachments for the 5xi series tractors
should be level side-to-side within about 3/16 inch
(4.76mm). However the adjustment point for the
60-inch (152.4cm) mower is different than the other
models.
44-, 48-, 52-inch (111.7, 121.9, 132.0cm) Mowers
Equalize side-to-side cut by adjusting the two carriage
bolts on the gage wheel shaft on the back of the mower
(Figure 65).
Figure 63
.TIF
Yet another way to check this with the blades attached
is to align the blades (two blades at a time on three
blade mowers), then run a string across the cutting tips
of the blades. The string should be straight. If it is not,
the blade or spindle could be bent.
If the saddles or blades do not line up and the spindles
are not bent, a shim between the spindle housing and
the mower housing may help align them. Loosen the
spindle to mower housing bolts and insert shim
Figure 65
5XI_S2S1.TIF
1.
Carriage bolts
washers until the saddles are in line. Then if you used
4 - 20
Service Dealer’s Guide to Great Quality of Cut
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Model Year | 2002 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Toro Lawnmower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Product Type | Walk Behind Mower |
| Engine Manufacturer | Briggs & Stratton |
| Engine Motor Type | 2 Cycle, 2 Cycle CARB1, 2 Cycle EPA1, 2 Cycle EPA2, 4 Cycle |
| Transmission Type | Hand Push |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)