Repair instructions
Ignition module and flywheel – refitting
3
1
Place the flywheel on the crankshaft. Turn the
flywheel so that the key lines up with the keyway in
the shaft.
Fit the washer and nut on the shaft and tighten to a
torque of 25-30 Nm.
Then refit:
•
cable guide and press the leads into position
• HT lead
•
starter assembly, tighten to a torque of 2.5–3.5
Nm
2
•
cylinder cover
0,3 mm
To refit the ignition module proceed as follows:
Turn the flywheel so that the magnets are in line
with the ignition module. Fit the ignition module
with the plastic feeler gauge (502 51 34-01) held
in position at the same time, without tightening
the bolts. Connect the black earth lead to the
front screw on the ignition module. Adjust the gap
between the ignition module and magnet to 0.3
+/-
0.1 mm. The gap must be measured at either of
the two lowest pegs on the ignition module. Tight-
en the bolts to 4.5–6 Nm. Connect the blue lead to
the ignition module.
English – 26
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 340, Husqvarna 345, Husqvarna 346XP, Husqvarna 350, Husqvarna 351, Husqvarna 353 |
| Model Year | 2003, 2004, 2005, 2006 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)