Repair instructions
Piston and cylinder – refitting 340, 345
Cylinder – pressure testing
1-5
See Piston and cylinder 346XP, 350, 351, 353
–Refitting points 1-5.
6
Apply silicone adhesive/sealing compound (03-
7062)
to the crankcase’s contact surfaces with the
cylinder.
Carefully slide the cylinder down over the piston
towards the big end bearing.
Note!
Work is facilitated if the crankshaft complete with
bearing and piston is released from the crankcase
and the piston is pushed into the cylinder. The unit
is then refitted in the crankcase.
7
•
•
•
Loosen the carburettor bolts so that the carbu-
rettor can be moved back about 4 mm. Insert
cover plate 502 54 11-02 between the carbu-
rettor and the carburettor flange. Tighten the
carburettor bolts to a torque of 1–1.5 Nm.
Loosen the silencer bolts so that the silencer
can be moved back about 4 mm. Insert cover
plate 502 54 11-02 between the silencer and the
exhaust flange on the cylinder flange. Tighten
the silencer bolts to a torque of 8–10 Nm.
Unscrew and remove the spark plug. Screw in
pressure test nipple 503 84 40-02. Connect tool
502
50 38-01 to the nipple. The decompression
Fit the cylinder bolts, tightening crosswise to a
torque of 13–15 Nm.
valve must be closed. The decompression valve
must be closed. To check the decompression
valve itself, see “Decompression valve – pres-
sure testing”.
8
Pressure test the cylinder.
•
•
•
Pump up the pressure to 80 kPa (0.8 bar).
Wait 30 seconds.
9
Refit:
The pressure should not be less than 60 kPa
•
•
•
•
spark plug, tighten to a torque of 15 Nm
carburettor, see “Carburettor – refitting”,
silencer, tighten to a torque of 8–10 Nm
cylinder cover
(0.6
bar).
•
Remove the cover plates from the silencer and
carburettor, tighten the bolts to the specified
torque. Remove the pressure test nipple 503 84
40-02
and refit the spark plug.
WARNING!
NOTE!
After pressure testing the cylin-
der, check that the inlet manifold
is seated correctly, otherwise the
saw may be damaged.
If a new piston or cylinder has been fit-
ted the saw must be run for the first 3–4
hours with carburettor adjusted to the
factory settings.
English – 45
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 340, Husqvarna 345, Husqvarna 346XP, Husqvarna 350, Husqvarna 351, Husqvarna 353 |
| Model Year | 2003, 2004, 2005, 2006 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)