Repair instructions
2
5
Connect the leads to the stop switch.
Carburettor heater 346XP, 351, 353
–
Refitting
Fit the carburettor. Screw in the carburettor bolts
directly from behind, without lifting the carburet-
tor assembly. Tighten to a torque of 1–1.5 Nm. It
is important to hold the carburettor flange while
tightening the bolts to prevent the inlet manifold
from moving.
Heating element
3
1
Push the rear carburettor mounting into its rubber
bushing using a small screwdriver. Remove stop
plate 502 54 17-01.
Fit the heating element between the air filter con-
nection and the carburettor as well as above the
carburettor.
4
2
Tighten the bracket above the carburettor using the
two bolts.
3
Connect the leads to the carburettor heater.
Refit:
•
carburettor
Connect the fuel hose to the carburettor. Refit the
throttle pushrod at the same time as the rubber
inlet manifold, press in the throttle pushrod so that
it engages in the carburettor and fit the spring.
English – 35
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 340, Husqvarna 345, Husqvarna 346XP, Husqvarna 350, Husqvarna 351, Husqvarna 353 |
| Model Year | 2003, 2004, 2005, 2006 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)