Toro 04021 04200 Greensmaster Flex 21 Lawn Mower Operators Manual, 2005

This mounting bolt has an offset, which when
rotated, acts as an eccentric (cam) to raise or lower
the roller. There is an I.D. dot which denotes the
offset of the bolt. Dot indicates in which direction
right end of roller moves when bolt is turned and
should always be in the rear half of the arc as
shown in Figure 48 .
Figure46
1.
Transmissioncoupling
7.
Reverse procedure to install cutting unit.
LevelingtheRearRollerto
theReel
Figure48
1.
Eccentricbolt
1.
Position cutting unit on a flat,  level surface
preferably a precision ground surface plate.
Note: If additional adjustment is required, replace
the screw on the left-hand bracket with another
eccentric bolt, Part No. 105-3833.  Ensure both
rear roller brackets are in the same hole.
2.
Place a 1/4 in. (6.4 mm) or thicker plate under the
reel blades and against front edge of bedknife.
Note: Be sure the plate covers the full length of
the reel blades and three blades contact.
6.
To verify if roller is level, try inserting a piece of
paper under each end of roller.
3.
4.
Firmly press down on cutting unit and maintain
pressure on rear roller. Try inserting a piece of
paper under each end of the roller. If the gap is
greater than the piece of paper, on either end, an
adjustment may be required, proceed to step 4.
7.
When roller is level, tighten nuts securely.
AdjustingtheBedknifeto
theReel
Loosen locknuts securing right rear roller bracket
to cutting unit sideplate (Figure 47 ).
Bedknife to reel adjustment is accomplished by
loosening or tightening bedbar adjusting screws,
located on top of mower.
1.
2.
Position machine on a flat, level work surface.
Make sure reel contact is removed by turning
bedbar adjusting screws counterclockwise
(Figure 49 ).
Figure47
1.
Rightrearrollerbracket
2.
Locknuts
5.
While holding reel securely  on plate and
maintaining pressure on rear roller, rotate lower
right roller mounting bolt (Figure 48 ).
29
Product Specification
CategoriesLawn Mower Manual, Toro Lawn Mower Manual
Tags, ,
Model Number04021, 04200
Model Year2005
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 36 pages
Document TypeOperator's Manual
LanguageNederlands, English, ελληνικά, Português, Svenska
Product NameToro Greensmaster Flex 21
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Product TypeWalk Behind Mower
Product SeriesToro Greensmaster - Flex Series
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website