AUGER GEARBOX
Gearbox Assembly
3. Insert the key into the shaft and slide the worm gear
into place. Note: There is a large letter R and an
arrow stamped into the side of the gear. This gear
MUST be installed such that the R and the arrow
are on the right hand side and the arrow is pointing
forward, from the operator’s point of view (Fig. 094).
This is a two-piece gear that is bonded together. If it
is installed backwards, the forces try to separate the
gear and can result in failure.
1.
Use a wire brush or fine sandpaper to clean the
auger shaft. A clean, smooth shaft will help avoid
damage when installing new bushings and seals.
Clean the old seal material from the case mating
surfaces. Scrape, then use liquid gasket remover.
(Fig. 092).
Fig 092
DSC-1167
Fig 094
MVC-047X
2.
If new bushings are to be installed in the gear case
halves, now is the time. Apply a thin coat of Loctite
Blue #242 or equivalent to the OUTSIDE of the
bushing and press in flush with the INSIDE of the
case (Fig. 093). This will allow space for the seal on
the outside. Wipe up any Loctite that is visible. The
Loctite must not get into the gear or seal area.
4.
Install the thrust washers and slide the case halves
on. Note the direction to keep the gear markings on
the right side.
Fig 093
MVC-710X
7-8
Power Max Service Manual
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro Power Max 1028LE, Toro Power Max 826LE, Toro Power Max 828LE, Toro Power Max 828LXE, Toro Power Max 828OE, Toro Power Max 828OXE |
| Model Year | 2005 |
| Download File |
|
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)