AUGER GEARBOX
5.
To assemble the worm shaft, start with the end
opposite the worm. Install a snap ring (sharp edge
towards the rear of the gearbox), thrust washer,
thrust bearing, thrust washer, bushing and seal.
There is also a bushing on the worm end of the seal
(Fig. 095).
7. Clean the case halves by scraping; then apply a
liquid gasket remover. To ensure a good seal case
halves must be clean and dry. Apply a thin coat of
Hylomar (Toro PN 505-129) to both halves. Allow
it to cure until it is dull and tacky, at least one hour.
Then assemble.
8.
Apply a light coat of oil or anti-seize to the gear case
screws. Tighten them in an X pattern to 120 in-lbs.
(15kg/m)
(Fig. 097).
9
3
5
2
1
7
8
Fig 095
DSC-0028
6
4
6.
Apply a VERY light coat of Loctite Blue # 242 or
equivalent to the outer diameter of the bearing. The
Loctite should not squeeze out when everything is
tightened or you used too much (Fig. 096).
Fig 097
MVC-844XA
9.
Lightly oil a seal protector and slide new seals down
the auger shaft. The lip of the seal should face
towards the inside. Seat the seals so the outer edge
is just flush with the outside of the gearcase.
Fig 096
DSC-0059
Power Max Service Manual
7-9
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro Power Max 1028LE, Toro Power Max 826LE, Toro Power Max 828LE, Toro Power Max 828LXE, Toro Power Max 828OE, Toro Power Max 828OXE |
| Model Year | 2005 |
| Download File |
|
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)