IMPORTANT: DO NOT operate starter more
than 15 seconds per minute, as overheating
and damage can occur. (If engine does not
start, refer to Troubleshooting.)
Tips for Operation
Snow is best removed as soon as possible
after snow fall.
To clear an area, run unit in an overlapping
series of paths. For large areas; start in the
middle and throw snow to each side, so snow
is not cleared more than once.
7.
8.
Adjust choke as needed.
Set throttle to Part Throttle or Slow
position for travel or adaptation to outside
temperature. Once achieved, set throttle
to Fast position for normal operation.
ALWAYS direct snow away from area to be
cleared and with direction of the wind.
Shut Off
TRAVELING
1.
Release Traction Drive Clutch Lever and
allow unit to come to a complete stop.
Run Impeller a few minutes after use to
prevent freeze-up of Impeller.
To travel from one work area to another:
2.
1.
2.
3.
Set Throttle to Slow or Part-Throttle
position.
3.
Release Attachment Clutch Lever and
wait for all moving parts to come to a
complete stop.
Press down on handlebars enough to
raise front of unit slightly off surface.
Engage wheel drive clutch without
engaging attachment drive clutch.
4.
5.
Move Throttle to the “Stop” position.
Remove key.
TRANSPORT
SNOW REMOVAL
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting unit
on a truck or trailer.
IMPORTANT: Allow unit and engine to adjust
to the outdoor temperatures before clearing
snow.
NOTE: Attachment clutch should be engaged
before wheel drive clutch when throwing snow.
Use extra care when loading or unloading unit
onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
1.
2.
3.
Select Speed Control position and
direction.
Engage Attachment Clutch - Right Hand
Lever.
DO NOT transport machine while engine is
running.
Engage Traction Drive Clutch - Left Hand
Lever.
IMPORTANT: DO NOT overload unit capacity
by attempting to clear snow at too fast a rate.
Use slow speed to clear deep or hard packed
snow.
MAINTENANCE
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine manufacturer's
service center.
Place unit on a flat level surface. Tip unit
forward onto front of impeller housing for
service. Assure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur and remove battery
(if equipped). Ensure unit is secure
and will not tip over during
maintenance.
GB - 19
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 1124, Ariens 1128, Ariens 1332, Ariens 1336, Ariens 8524, Ariens 924118, Ariens 924121, Ariens 924122, Ariens 924332, Ariens 924505, Ariens 924506, Ariens 924508, Ariens 924551 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)