CLEAN ENGINE
MAINTENANCE SCHEDULE
Refer to Engine Manual for detailed
instructions.
Service
Each Every Every Yearly
Performed
Use
5 hrs.
25
CHECK ENGINE OIL
hrs.
The engine crankcase oil should be checked
every 5 hours of operation. Oil level MUST be
maintained in safe operating range on dipstick
at all times or engine damage will result (See
Engine Manual).
Check Dual
Handle
•
Interlock
Check
Fasteners
•
•
•
Park unit on a level surface. Refer to Engine
Manual for detailed instructions.
Check
Clutches
CHANGE ENGINE OIL
Clean Engine
Change oil after first 2 hours of operation,
thereafter change oil every 25 hours (more
often if required). Refer to Engine Manual for
detailed instructions.
Check Engine
Oil
•
Change
*
•
•
•
•
•
Run engine just prior to changing oil. Warm oil
will flow more freely and carry away more
contamination.
Engine Oil
Check Tire
Pressure
CHECK TIRE PRESSURE
Check Auger
Gearcase
•
•
•
Keep tires at pressure listed on the tire
sidewall.
General
Lubrication
CHECK AUGER GEARCASE
IMPORTANT: Proper oil level must be
maintained.
Battery
Maintenance
Gear cases are filled to the correct level at the
factory. Unless there is evidence of leakage,
no additional lubricant should be required.
Check oil level each season or every 25 hours
of operation.
*
After first two hours of operation.
CHECK DUAL HANDLE
INTERLOCK
To ensure adequate lubricant level:
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage.
1. Remove filler plug (Figure 10). Lubricant
must be at least up to bottom of lubricant
filler hole with unit resting on a
level-surface.
2.
Add lubricant if required. Allow oil to drain
to level of plug and replace plug.
IMPORTANT: Use only Ariens special gear
lubricant L-2 (Part Number 00008000).
CHECK FASTENERS
Make sure all hardware is tightened properly.
CHECK CLUTCHES
Auger / impeller must stop within 5 seconds
when attachment clutch/impeller brake lever is
released.
Wheels must stop quickly when traction drive
clutch lever is released.
If clutches do not engage or disengage
properly, adjust or repair before operation (see
Service and Adjustments).
GB - 20
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 1124, Ariens 1128, Ariens 1332, Ariens 1336, Ariens 8524, Ariens 924118, Ariens 924121, Ariens 924122, Ariens 924332, Ariens 924505, Ariens 924506, Ariens 924508, Ariens 924551 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)