8.
Replace belt cover.
CAUTION: Always support Sno-Thro
frame and blower housing when
loosening the cap screws holding
them together. Never loosen cap
screws while unit is in service
position.
TRACTION DRIVE BELT
REPLACEMENT
NOTE: Housing and frame must be tipped
apart and attachment drive belt removed from
engine sheave in order to change traction
drive belt.
8.
9.
Remove cap screws securing housing to
frame (one on each side). Tip housing
and frame apart on pivot pins (Figure 20).
1.
Remove attachment drive belt (see
Attachment Drive Belt Replacement).
2.
Pull idler away from traction drive belt and
remove belt from idler pulley, engine
sheave and driven pulley (it may be
necessary to turn engine pulley using
recoil handle).
Remove attachment drive belt from
attachment pulley (hold brake away from
belt).
Install new attachment drive belt:
1.
Place new attachment belt onto
attachment pulley.
Tip housing and frame back together and
secure with cap screws.
NOTE: To gain clearance, engage traction
clutch and if necessary pull back attachment
idler arm clevis pin.
3. Install new traction drive belt onto
attachment pulley and engine sheaves.
2.
3.
4.
Place belt onto engine sheave.
Make sure engine sheave and
attachment pulley align. If alignment is
necessary, loosen attachment pulley set
screws, reposition pulley and retighten
set screws.
4. Replace attachment drive belt (See
Replace Attachment Drive Belt).
FRICTION DISC REPLACEMENT
1. Place unit into service position.
5.
Reposition and secure belt fingers.
2. Remove bottom cover by removing four
cap screws.
IMPORTANT: Make sure belt fingers are
in. to 1/8 in. (1.6-3mm) from belt when
1/16
3.
Place speed selector in first (1) position
and depress traction clutch lever to hold
friction disc and hub in position.
attachment clutch is engaged.
6.
Check adjustment. See Attachment
Clutch/Brake.
4.
5.
6.
Remove cap screws from hub
(Figure 22).
WARNING: AUGER / IMPELLER
MUST STOP within 5 seconds when
attachment clutch lever is released or
unit damage or serious injury may
result.
Release traction clutch lever, shift to third
(3) position, and remove friction disc.
Secure new friction disc on hub with five
cap screws and torque cap screws to
8-10 lbf-ft (10,6-13,3 N•m).
7.
Reconnect chute crank and secure with
spring clip. If equipped, reconnect remote
cap deflector cable and/or electric chute
wire harness.
7.
8.
Replace bottom cover.
Adjust traction drive clutch (see Traction
Drive Clutch Adjustment).
1
2
3
1. Cap Screw
2.
3.
4.
5.
Cotter Pin
Friction Disc
Shift Arm
Chain
6
4
6. Idler Hex Shaft
OS0612
5
Figure 22
GB - 27
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 1124, Ariens 1128, Ariens 1332, Ariens 1336, Ariens 8524, Ariens 924118, Ariens 924121, Ariens 924122, Ariens 924332, Ariens 924505, Ariens 924506, Ariens 924508, Ariens 924551 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)