GENERAL LUBRICATION
1
IMPORTANT: Wipe each fitting clean before
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to
get on friction disc, friction plate or belts.
2
NOTE: Apply Stens Mix Hi-Temp Grease or
equivalent to the lubrication fittings. See
Service Parts.
Sno-Thro should be lubricated (Figure 11) at
beginning of season or every 25 operating
hours.
3
Auger Shaft
2
NOTE: To grease auger shaft, remove shear
bolt nuts, and shear bolts. Turn auger on shaft
while applying grease at zerk fittings. Replace
shear bolt per instructions in Service and
Adjustments.
1.
2.
Auger Gearcase - Cast Iron
Oil Fill and Drain Plug
3
. Auger Gearcase - Aluminum
Figure 10
2
8
6
5
4
1
1
1
1
7
3
1.
2.
3.
Auger and Shaft
5. Shift Lever Arm
6. Pinion Chain
7. Hex Shaft
8. Shift Link
Discharge Chute
Sprocket/Pinion
Assembly
Grease
Oil
4.
Axle Shaft
OS0641
OS0741
Figure 11
CLEAN BATTERY (924332, 505,
506, 508)
Terminals
Keep battery and its terminals clean.
IMPORTANT: Remove battery from unit
before cleaning.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Remove corrosion from battery terminals and
cable connections with a wire brush, then
wash with a weak baking soda solution.
IMPORTANT: Battery is maintenance free. Do
not tamper with or attempt to open battery.
See Service and Adjustments for charging
procedures.
After cleaning, apply a thin coat of grease or
petroleum jelly to terminals and cable ends to
retard corrosion.
GB - 21
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 1124, Ariens 1128, Ariens 1332, Ariens 1336, Ariens 8524, Ariens 924118, Ariens 924121, Ariens 924122, Ariens 924332, Ariens 924505, Ariens 924506, Ariens 924508, Ariens 924551 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)