ATTACHMENT CLUTCH/BRAKE
ADJUSTMENT
(Figures 18 and 19)
3
IMPORTANT: IMPROPER
ADJUSTMENT could result in
unexpected movement of auger and
impeller causing death or serious
injury. Auger / impeller must stop
within 5 seconds when Attachment
Clutch/Impeller Brake lever is
released.
4
2
1.
2.
Remove belt cover.
Check belt alignment (Figure 21).
Engine sheave and attachment pulley
must align vertically. Also, belt must be
centered in the idler pulley.
1
To align, move attachment pulley:
a.Loosen set screws.
b.Slide pulley and key to desired
position.
1.
2.
3.
4.
Shift Rod
Adjustment Pivot Pin
Speed Selector Lever
Hairpin
c.Tighten set screws.
Install belt cover.
3.
4.
Adjust cable slack.
IMPORTANT: The belt cover must be installed
and the clutch cable must be slack when the
lever is disengaged.
Figure 17
a.With clutch lever disengaged, loosen
jam nut on cable adjuster.
b.Turn adjuster body to remove all slack
from the cable. Do not stretch spring
or move lower clutch arm.
c.Turn back the adjuster body 5 turns
(approximately 1/4 in. or 6 mm).
Finger tighten jam nut.
d.Hold adjuster body with pliers and
tighten jam nut with wrench.
5.
Check spring length.
a.Measure the length of the clutch cable
spring.
b.Engage and hold the attachment
clutch lever.
c.Measure the length of the spring
again. The spring should be
7/16
–11/16 in. (11.1–17.5 mm) longer
when the lever is engaged.
GB - 24
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 1124, Ariens 1128, Ariens 1332, Ariens 1336, Ariens 8524, Ariens 924118, Ariens 924121, Ariens 924122, Ariens 924332, Ariens 924505, Ariens 924506, Ariens 924508, Ariens 924551 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)