2.
3.
4.
5.
Remove two screws securing belt cover to unit
and remove belt cover.
Remove spring pin from chute crank rod assembly
at universal joint and separate.
Grease
Oil
Remove belt finger by removing cap screw
mounting belt finger to engine.
Remove attachment drive belt from engine sheave
(it may be necessary to turn engine sheave using
recoil starter handle).
CAUTION: Always support Sno-Thro frame and
housing when loosening the cap screws holding
them together. Never loosen cap screws while
unit is in service position.
IMPORTANT: To avoid bending bottom cover, when
tipping unit apart, support handlebars firmly or tip unit
up on housing and remove bottom cover by removing
four cap screws before separating unit.
6.
7.
Support Sno-Thro frame and housing (Figure 5).
Remove top two cap screws and loosen lower cap
screws holding blower housing to frame (one on
each side).
OS1373
8. Hold the brake away from the attachment pulley
and separate housing from unit. Lower handlebar
on floor.
Figure 8
Auger Shaft
9.
Remove attachment drive belt from lower pulley
(hold brake away from belt).
NOTE: To grease auger shaft, remove shear bolt nuts,
and shear bolts. Turn auger on shaft while applying
grease at zerk fittings. Replace shear bolt per instruc-
tions in Service and Adjustments.
2
1
3
4.8
ENGINE
Cooling
6
The engine is air cooled. Air must circulate freely
around engine from air intake to cooling fins on cylinder
head and block, to prevent overheating.
7
Each year (more often if conditions require) remove
cooling shrouds and clean cooling fins. Clean external
engine surfaces of dust, dirt, and oil deposits which can
contribute to improper cooling. See Engine Manual.
IMPORTANT: DO NOT operate engine with cooling
shrouds removed. Engine overheating and damage will
result.
4
Refer to Engine Manual for detailed instructions.
4.9
REPLACEMENT
ATTACHMENT DRIVE BELT
OS7240?
5
Remove Attachment Drive Belt
1. Pinion and Gear
5. Bottom Cover
6. Belt Cover
7. Universal Joint
2.
3.
4.
Spring Clip Pin
Chute Crank
Housing Bolt Holes
See Figures 9 and 10.
1.
Shut off engine, remove key, disconnect spark plug
wire and allow unit to cool completely.
OS0802
Figure 9
4
- 18
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932045, Ariens 932046, Ariens 932047, Ariens 932048, Ariens 932311, Ariens 932312 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)