SECTION 8 - REDUCTION DRIVE
8.1
WHEELS AND AXLE
The wheels are held onto the axle with locking pins
(Figure 22). To remove a wheel pull the locking pin and
the wheel will slide off.
5
8
9
To remove the axle:
1.
Place the unit in upright service position as shown
in Figure 5.
6
7
2.
Remove the lock pins from both ends of the wheel
axle and remove both wheels.
3.
4.
5.
Remove two bolts from top of bottom cover.
Loosen two bottom screws and slide cover off.
5
4
Slide axle out either side. Be sure to catch larger
spur gear when removing axle.
3
2
NOTE: Make a record of the positions for the washers
and flanges for reassembly.
1
To install the axle:
1. Axle Lock Pin
6. Axle
2.
3.
4.
Wheel
Steel Washer
Flanged Bushing
7. Spur Gear
8. Bolt w/Nut
9. Roll Pin
1.
Slide the axle into the main frame from either
direction.
2.
Place flange bushing, washers, and spur gear on
the axle in the correct order.
5. Steel Washer
Figure 22
PS0333_1
NOTE: The flat side of the spur gear goes against the
frame. The flange bushings are installed from inside
the frame. The axle must enter into the bushings from
inside the frame toward the outside.
3.
4.
Insert the roll pin.
Install the bolt through the spur gear and install the
nut.
5.
6.
Slide washers on axle shaft outside of frame.
Slide wheels on axle shaft and install locking pins.
8
- 30
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932045, Ariens 932046, Ariens 932047, Ariens 932048, Ariens 932311, Ariens 932312 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)