ENGINE TROUBLESHOOTING
PROBABLE CAUSE
PROBLEM
CORRECTION
Poor Compression
Leaking cylinder head gasket
Incorrect tappet adjustment
Sticking valves
Replace per instructions in manufacturer’s manual
Adjust per instructions in manufacturer’s manual
Repair per instructions in manufacturer’s manual
Repair per instructions in manufacturer’s manual
Repair per instructions in manufacturer’s manual
Repair per instructions in manufacturer’s manual
Repair per instructions in manufacturer’s manual
Replace per instructions in manufacturer’s manual
Fill tank
Worn cylinder bores
Pitted valves and seats
Broken, worn, or sticking piston ring(s)
Worn valve stems and guides
Broken valve spring
Starts and Stops
Vibration
Fuel tank empty
Bad spark plugs
Install new spark plugs
Poor compression
Repair per instructions in manufacturer’s manual
Lubricate or replace
Sticking throttle/restricted movement
Leaking cylinder head gasket
Overheating
Replace per instructions in manufacturer’s manual
Allow to cool; determine cause
Sticking valves
Repair per instructions in manufacturer’s manual
Repair per instructions in manufacturer’s manual
Adjust per instructions in manufacturer’s manual
Broken, worn, or sticking piston rings
Incorrectly aligned flywheel and/or
flywheel housing
Will Not Crank
Will Not Start
Bad electrical connection
Bad spark plugs
Check connections to electric start (if applicable)
Replace spark plugs; see manufacturer’s manual
for recommendations
See your engine manual for information on the operation and maintenance of your engine. Follow those instruc-
tions for oil and filter changes.
7.2
1.
REMOVING THE ENGINE
7.3 INSTALLING THE ENGINE
1. Position the engine in the frame.
2. Insert mounting bolts and tighten.
Drain gasoline.
2.
Remove both belts from the engine pulleys.
Remove pulleys.
3.
4.
5.
If equipped with electric starting, install the starter.
Reattach any brackets for chute/deflector controls.
3.
4.
5.
If the unit has a bracket at the top of the engine for
chute/deflector controls, unbolt it.
Install pulleys on engine shaft. Do not tighten set
screws.
If the unit is equipped with electric starting, remove
the starter.
6.
Install belts. Adjust the engine pulleys to align with
attachment and drive pulleys. Tighten set screws.
Remove the four mounting bolts from the engine
base.
7
- 29
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932045, Ariens 932046, Ariens 932047, Ariens 932048, Ariens 932311, Ariens 932312 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)