SECTION 10 - AUGER/IMPELLER
10.1
AUGER/IMPELLER REMOVAL
3. Grasp auger assembly and pull gear case and
auger/impeller assembly free of housing.
Remove shear bolts and remove auger from shaft.
Check all parts for wear or replacement.
Assemble using reverse procedure.
Place unit in the belt service position (Figure 5).
4.
5.
6.
1.
Remove bolt holding auger driven pulley to shaft
and remove pulley.
2.
Remove three tapping screws holding rake shaft
bushing to housing and remove bushing on each
side.
1
3
1.
2.
3.
4.
5.
6.
Tapping Screw (typical of 3)
Rake Shaft Bushing
Runner (1 each side)
Auger Assembly
Scraper Bar
Shear Bolt (typical of 2)
3
5
2
5
4
1
6
2
PS0363_1
Figure 25
10.2
SHEAR BOLTS
3. Secure with nut.
WARNING: Stop engine, remove key, wait for
moving parts to stop and remove wire from
spark plug before leaving operator’s position
and attempting to maintain or inspect auger.
2
IMPORTANT: Use only Ariens shear bolts for
replacement. Use of any other type of shear bolt may
result in severe damage to unit.
Occasionally an object may enter auger/impeller
housing and jam auger, breaking shear bolts which
secure auger to shaft. This allows auger to turn freely
on shaft preventing damage to gear drive.
1
To replace shear bolt:
1
1.
2.
Shear Bolt
Auger Shaft
1.
Slide auger outward against roll pin and align hole
in shaft with hole in auger (Figure 26). The holes in
shaft for roll pins and shear bolts will line up.
Figure 26
OS7150
2.
Drive the new shear bolt through hole (if shear bolt
was broken this will drive remaining part from
shaft).
10
- 33
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932045, Ariens 932046, Ariens 932047, Ariens 932048, Ariens 932311, Ariens 932312 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)