Before cleaning, removing clogs or making any
inspections, repairs, etc.: disengage clutch(es),
stop unit and engine, remove key, allow moving
parts to stop. Allow hot parts to cool.
NEVER fill fuel tank when engine is running or hot from
operation.
NEVER fill or drain fuel tank indoors.
Replace fuel cap securely and clean up spilled fuel.
Run unit a few minutes after clearing snow to prevent
freeze-up of attachment.
Never fill containers inside a vehicle or on a truck or
trailer bed with a plastic liner. Always place containers
on the ground away from your vehicle before filling.
Disengage attachment when not in use. Disengage all
clutches before starting engine. Adjust runners to clear
gravel or crushed rock surfaces safely.
When practical, remove gas-powered equipment from
the truck or trailer and refuel it on the ground. If this is
not possible, then refuel such equipment on a trailer
with a portable container, rather than from a gasoline
dispenser nozzle.
Disengage clutch bail when not in use. Before starting
engine: disengage clutch bail. DO NOT use on gravel
or crushed rock surfaces.
Check clutch and brake operation frequently. Adjust
and service as required. All motion of auger must stop
quickly when bail is released.
Keep the nozzle in contact with the rim of the fuel tank
or container opening at all times until fueling is
complete. Do not use a nozzle lock-open device.
Never leave a running unit unattended. ALWAYS
disengage PTO, lower the attachment, set parking
brake, and shut off engine before leaving unit.
ALWAYS remove key to prevent unauthorized use.
If fuel is spilled on clothing, change clothing
immediately.
In case of internal contact, DO NOT induce vomiting!
Before tipping unit up onto housing, remove fuel so no
spills will occur and remove battery. Ensure unit is
secure and will not tip over during maintenance.
Never carry passengers.
Check clutch and brake operation frequently. Adjust
and service as required. All motion of drive wheels and
auger/impeller must stop quickly when control levers
are released.
ALWAYS keep protective structures, guards, and
panels in good repair, in place and securely fastened.
NEVER modify or remove safety devices.
DO NOT operate on steep slopes. DO NOT clear snow
across the face of slopes. Keep all movement on
slopes slow and gradual. DO NOT make sudden
changes in speed or direction. Use a slow speed to
avoid stops or shifts on slopes. Avoid starting or
stopping on a slope.
DO NOT change engine governor settings or over-
speed engine.
Fumes from engine exhaust can cause injury or death.
DO NOT run engine in an enclosed area. Always
provide good ventilation.
ALWAYS maintain unit in safe operating condition.
Damaged or worn out muffler can cause fire or
explosion.
DO NOT park unit on a slope unless absolutely
necessary. When parking on a slope always block the
wheels.
Keep all hardware properly tightened. Check shear
bolts frequently. Check slip clutch on units so
equipped.
ALWAYS shut off engine, remove key, and close fuel
shut-off valve or drain fuel when transporting unit on a
truck or trailer.
Maintain or replace safety and instruction labels, as
necessary.
Use extra care when loading or unloading unit onto
trailer or truck.
NEVER store unit with fuel in fuel tank, inside a
building where any ignition sources are present such
as hot water heaters, space heaters, or clothes dryers.
Allow the engine to cool before storing in any
enclosure.
Secure unit chassis to transport vehicle. NEVER
secure from rods or linkages that could be damaged.
DO NOT transport machine while engine is running.
Keep unit free of ice or other debris. Clean up oil or fuel
spills.
Stop engine, shut off fuel, and allow engine to cool
completely before storing in closed area or covering
unit.
This product is equipped with an internal combustion
type engine. DO NOT use unit on or near any
unimproved, forest-covered or brush-covered land
unless exhaust system is equipped with a spark
arrester meeting applicable local, state or federal laws.
A spark arrester, if it is used, must be maintained in
effective working order by operator.
For extended storage, clean unit thoroughly. See
Engine Manual for proper storage.
Use only attachments or accessories designed for your
unit.
Check components frequently. If worn or damaged,
replace with manufacturer’s recommended parts.
Fuel is highly flammable and its vapors are explosive.
Handle with care. Use an approved fuel container.
NO smoking, NO sparks, NO flames. ALWAYS allow
engine to cool before servicing.
2
- 9
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932045, Ariens 932046, Ariens 932047, Ariens 932048, Ariens 932311, Ariens 932312 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)