SECTION 11 - GEAR CASE
11.1
ALUMINUM GEAR CASE
4. When replacing bushings make sure the flat on the
flange of bushing fits in the inside notch of the
case.
1.
2.
3.
Remove auger/impeller and gearcase from
housing referring to Auger/Impeller Section.
5.
There are two special thrust washers, one on
either side of worm gear. If burred or worn, they
should be replaced.
Remove eight bolts that hold right and left gear
case halves together (Figure 29).
If flange bushings need replacement, first remove
seals from outside of gearcase halves with a
screwdriver. Flange bushings can then be pressed
out from outside in with a bearing driver. Bushings
are very lightly pressed in.
6.
7.
Holding the worm gear on rake shaft is a woodruff
key.
Remove bronze bushing from front of worm shaft
by sliding it off. Replace if necessary. Notice that a
flat on the bushing flange positions the bearing
inside the gearcase.
22 21 20
24
23
19
14
15
16
25
17
18
12 13
11
26
10
8
9
6
5
7
4
PS0381_1
1
2
3
1.
2.
3.
4.
5.
6.
7.
8.
9.
L2 Lube (16 oz)
Flat Washer (steel)
Oil Seal
Gearcase (right side)
Rake Shaft
Flange Bushing
Oil Seal
Worm Gear
10.Flange Bushing
11.Flange Bushing
12.Gearcase (left side)
13.Tapping Screw with Fiber
Washer
14.Steel Washer
15.Oil Seal
16.Steel Washer
17.Sleeve Bushing
18.Loctite Gasket 518
19.Worm Shaft
20.Thrust Collar
21.Flange Bushing
22.Sleeve Bushing
23.Groove Pin
24.Impeller
25.Flange Bearing
26.Tapping Head Washer
Hex Screw
Woodruff Key
Figure 29
11
- 36
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932045, Ariens 932046, Ariens 932047, Ariens 932048, Ariens 932311, Ariens 932312 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)