IMPORTANT: Before plugging the wire harness
power connector to the engine ECM, make sure that
theignitionswitchisintheOFFpositionandthekey
is removed from the switch. If the harness power
connector is plugged into the engine ECM while
electrical power is on, the ECM will be damaged.
16.Raise and lower cutting decks several times. Turn
steering wheel fully left and right several times.
17.Shut
offengineandcheckentiremachineforhydrau-
licoilleaks.Checkoillevelinhydraulicreservoirandadd
correct amount of oil if necessary.
18.Operate
conditions.
machinefor2hoursundernormaloperating
13.Connect
gine ECM (Fig. 45).
thewireharnesspowerconnectortotheen-
19.Check
shows any signs of contamination, repeat steps 1
through 14 again until oil is clean.
condition of hydraulic oil. If the new fluid
14.Disconnect
test port (Fig. 46).
pressure gauge from charge pressure
15.Start
engine and let it run at low idle (1350 RPM) for
20.Assume
maintenance intervals.
normal operation and follow recommended
a minimum of 2 minutes. Increase engine speed to high
idle (2750 RPM) for a minimum of 1 minute under no
load.
Groundsmaster 5900/5910
Page 4 -- 63
Hydraulic System
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 5900, Toro Groundsmaster 5910 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)